Jump to content
SAU Community

Recommended Posts

Put my Series 1 RSFOUR on the Dyno last night to see if it made factory power and look at the A/F's. It made 180rwhp (had front driveshaft disconnected for RWD dyno'ing) at about 6500rpm on about 6-7psi (factory solenoid high mode). So if you figure on 240hp @flywheel, and maybe 25% losses then 180hp is about right.

But it was superduper rich throughout which I kinda see as a problem! At idle it achieved 13.5-14.5:1, so made me think the o2 sensor was working in closed loop mode, but at cruise (about 10in. Vac - 2000rpm - 4hp) it went straight to between 11.1 - 11.4 :1, stupidly rich. And on a full power run it goes off the meter at the top end, running around 10:1 before meter says 'too rich' and stops measuring.

I discovered the factory bov was leaking when we pressurised the intake path with an air compressor to check for leaks (had to disconnect and block the bov recirc line to check for bov leakage). So tried another std nissan bov they had lying around, it too leaked (both leaked from 2-6psi). Wondered if other ppl's might be? I squashed mine up in the vice to increase spring tension (butcher I know but gonna replace it), but still leaked. But it's full recirc after afm, so wouldn't be causing richness.

Sooo I'm thinking i'm on a hunt for faulty components causing the richness before I just tune it out with a piggyback. If something's wrong best I fix it instead of just tuning away.

But I'm wondering if other guys with std Stagea's have seen similiar A/f's on the dyno???

Link to comment
https://www.sau.com.au/forums/topic/116446-super-rich-stagea/
Share on other sites

Stock NIssan ECU's = SUPERMEGAHAPPYRICH fuel mixtures, my stock R33 ran as low as 7.5:1 running stock ECU, I would assume that the stock Stagea ecu would be about the same..?

All the RB25DET stock BOV's leak, if you do some searching you'll find out all kind of stuff about the stocker BOV.

Stock NIssan ECU's = SUPERMEGAHAPPYRICH fuel mixtures, my stock R33 ran as low as 7.5:1 running stock ECU, I would assume that the stock Stagea ecu would be about the same..?

All the RB25DET stock BOV's leak, if you do some searching you'll find out all kind of stuff about the stocker BOV.

I have a feeling that the Stagea ecu is slightly different, in the outer case at least), as in you cant read error codes on the ecu on a stagea but can on an R33 (true?).

I suggest getting a SAFC and tune that beast! 12:1 all the way.

Sweet I'm pleased to hear my car probably isn't broken and slammin' rich is the norm. You'd have to ask why though.. like what was running through the ecu engineer's mind? I know altitude - temp - etc but shit.

I'm probably planning on Greddy e-manage 2, supposedly they're the way. Dyno guy is tuning on one a car soon so he'll say how it goes. Bout 1k to buy, and has usb connection, designed for tuning with laptop which i figure is handy (if ya got one).

Tangles, is the SITC a little blue screen version of the ITC? I never knew they existed!

SITC had 5 dials that you can alter the Ignition Timing on....... no screens, although they give a nice glow when the powers on.

Apexi Super-ITC or Super Ignition Timing Converter

see SK's thread, pics and all: http://www.skylinesaustralia.com/forums/in...c=80642&hl=sitc

Edited by Tangles
wicked, im about to pick one up to compliment my SAFCII. It was sold as a ITC not a SITC, so I thought there might have been a difference.

Thanks mate.

No probs!!

I gained 20kw when I added the SITC and a fuel pump (direct wired) & Z32 afm, tuned at 12psi up from 10psi. Best of luck with it.

fyi: I got a Brand New SITC off ebay for $200US LOL, never ever seen another brand new one for sale.

As I said earlier I wanted to get the S1 tuned as I thought it was running a bit rich. 15+/100kms, plus the exhaust is very sooty.

All the technical terminology in this topic puts me off a bit.

What is a simple economical method of getting a tune up?

Take it to a trusted tuner, give him lots of $$ and get your vehicle back with a couple of extra piggyback ecu's and a decent tune. Easy :/

Or buy what Tangles bought, SAFC (Super Air Flow Converter I think..?) or a SAFCII (Same but a newer version) and the SITC (as explained by Tangles) and then install them yourself if you have the knowhow or take them to a tuner and get him to install and tune.

There are heaps of different ways to do this, all depending on price range and what tuner you take it to.

For example I have a Power-FC, which is a replacement ECU, but it had to be dodgy wired in because you cant buy one for a RSFour, but it allows a huge range of tuning capabilities. It would also cost you around the $1500 mark, plus all the stuffinf around to get it to work.

Or there is the GReddy E-Manage, which is a piggyback ecu, but has a lot of features, esp when combined with a Profec E-01. Again fairly expensive from what I have heard, ~$1500........?

Or there are several small piggyback ecu's you can get that do specific jobs, SAFC (Fuel mixture controller), SITC (ignition timing controller), AVCR (boost controller).

It all depends on what either your personal preference is or what your tuners preference is.

Not all tuners know or want to tune all ecu's, I havnt found anyone here in Rockhampton that can tune my Power-FC, mainly because I dont have a hand controller, so they would need to run some sort of program to control the Power-FC, like my old tuner in Brisbane did, meaning if I did want it re-tuned then I will have to drive down to Brisbane for a tune.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
×
×
  • Create New...