Jump to content
SAU Community

Recommended Posts

NO LONGER FOR SALE

In under two weeks i am getting my second skyline (R33)...

It has 2 R32 GTR wheels (black ones)

They are in very good condition with little to no scratches on them.

Tyres have plenty of tread on them.

Looking at offers over $500

NOTE: ONLY TWO WHEELS

NO LONGER FOR SALE

------------------------------------------------------------------------------------

Also has a set of 17' AVS wheels on it, plenty of tread and only one scratch on these...

offers over $600, again only two wheels

NO LONGER FOR SALE

cheers...

Link to comment
https://www.sau.com.au/forums/topic/12321-r32-gtr-wheels/
Share on other sites

  • 3 months later...

i know this car...

it has a sort of pearl in it yea?

it came with no back seat but a full on rollcage,

also was decked out in all sorts of computers, last time i heard he sold it for 21500

personally i wouldnt of touched that car as that bloke that was selling it is pretty dodgy (he had a black one that he BLEW up running stupid boost and used 2nd hand pistons and 2nd hand piston rings in the rebuild! had damage to the crank and didnt even get it machined!!) if this is the bloke u bought the car off make sure u check it out properly b4 u buy it, as far as i saw on that car the only good part to it was the toys it came with (4inch cannon exhaust was pretty tuff looking :D )

anyways good luck mate

Link to comment
https://www.sau.com.au/forums/topic/12321-r32-gtr-wheels/#findComment-451398
Share on other sites

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
    • This IS something you also have to configure in Haltech (or at least I did in the past when going from onboard-to-ECU map sensor and an external MAP sensor in haltech land).
    • I'm hoping it's something as simple as the ECU is looking for an external MAP sensor, but he is trying to use the onboard MAP sensor.
    • You won't need to do that if your happy to learn to tune it yourself. You 100% do not need to do that. It is not part of the learning process. It's not like driving on track and 'finding the limit by stepping over the limit'. You should not ever accidently blow up an engine and you should have setup the ECU's engine protection to save you from yourself while you are learning anyway. Plenty of us have tuned their own cars, myself included. We still come here for advice/guidance/new ideas etc.  What have you been doing so far to learn how to tune?
    • Put the ECU's MAP line in your mouth. Blow as hard as you can. You should be able to see about 10 kPa, maybe 15 kPa positive pressure. Suck on it. You should be able to generate a decent vacuum to about the same level also. Note that this is only ~2 psi either way. If the MAP is reading -5 psi all the time, ignition on, engine running or not, driving around or not, then it is severely f**ked. Also, you SHOULD NOT BE DRIVING IT WITHOUT A LOAD REFERENCE. You will break the engine. Badly.
×
×
  • Create New...