Jump to content
SAU Community

Recommended Posts

motec are looking for a system admin, sounds pretty good actually.

almost tempting. its on seek for those interested. at their research centre in croydon.

dyno on site among many other super cool tools i would imagine.

there would be some sweet equipment there, im sure their IT stuff would be top notch

Link to comment
https://www.sau.com.au/forums/topic/123855-sysadmin-job-motec/
Share on other sites

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

I had an interview for a position as a Software Engineer there on Wednesday.... we'll see how it goes :D

They gave me a tour of the place too :D

-Patrick

*shakes fist* no no no :dry:

Mine was at 10, when was yours?

damn..... that job would be perfect for me! Pity i still have 6 months left of uni :huh:

Fairly simple setup by the sounds of things. (yeah, $50-60k sounds right)

just do the last few subjects part time if you get the job. work experience is more important than uni experience (yes i went to uni full time, wish i didn't)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...