Jump to content
SAU Community

Bilstein/whiteline Suspension Struts

AlexCim
 Share

Recommended Posts

AlexCim Grand Master

AlexCim

Posted
Posted

Bought these about 10,000km ago.

Both front and rear struts for sale as complete units. Want exchange for stock suspension struts (need something to drive the car around with). Rear shocks also have new dust cover kits

Heights are already set at nice streetable heights so no need to change them, just 3 bolts to remove each strut and repalce, off you go. Much easier than what I did.

All 4 as a package, cost me $1300 new and I've assembled them and trial and error'ed the heights, asking $800 + freight the lot WITH SWAPOVER for stock suspension struts.

Will have pictures up in the next few days.

Phone:0439 909 610

Link to comment
https://www.sau.com.au/forums/topic/124755-bilsteinwhiteline-suspension-struts/
Share on other sites
AlexCim Grand Master

AlexCim

Posted
  • Author
Posted
Hi

Any reason why you are selling your existing suspension?

I was also going to put in whiteline bushes into my GTT but if your selling them because they arent that good then I might reconsider.

Thanks

Champ, This is the best handling suspension package I have encountered in my life for the street.

The quality and engineering behind this entire kit is beyond imagination for the cost.

I am not selling it because of poor quality, rather my car is being returned back to standard in preparation for some repairs and then sale (Loose less with stock parts back on)

I 100% back this entire kit and I am certain you will be 100% satisfied with its performance. Infact, the next car is going to be an R32 GTS4. It currently has a full suspension package which I am removing to replace it all with the full R32 kit

Regards,

Alex

  • 8 months later...
Fassst Apprentice

Fassst

Posted
Posted
Bought these about 10,000km ago.

Both front and rear struts for sale as complete units. Want exchange for stock suspension struts (need something to drive the car around with). Rear shocks also have new dust cover kits

Heights are already set at nice streetable heights so no need to change them, just 3 bolts to remove each strut and repalce, off you go. Much easier than what I did.

All 4 as a package, cost me $1300 new and I've assembled them and trial and error'ed the heights, asking $800 + freight the lot WITH SWAPOVER for stock suspension struts.

Will have pictures up in the next few days.

Phone:0439 909 610

Hey just wondering where the struts are located?

Also what your selling, its that everything needed to lower the car? eg. don't need to buy springs or anything (sorry n00b here :bunny:)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • ARB26
      S1 Autech 260RS Wiring Diagrams

      By ARB26 · Posted

      I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...