Jump to content
SAU Community

Recommended Posts

I just bought Nulon Ultra Cool concentrated radiator treatment. Actually is this a proper coolant or did I just buy something useless for my Skyline? lol

I also got the Nulon Radiator Flush and Clean.

Umm, yeah, I bought that and was told its not recomended. I was looking at it in Sprchp today and theres some called 'Tefylon' or something like that and a Castrol branded AntiFreeze/AntiBoil, I'd go for one of them.

Also the concentration level is a recommended minimum (33% means add 1 part AF/AB and 2 parts distilled water) so IMO I would create a mixture of 40-50%.

The flush I guess is fine.

Link to comment
https://www.sau.com.au/forums/topic/126877-coolant/page/2/#findComment-2396171
Share on other sites

If you buy the concentrate buy the stuff that has the proper glycol content, It should be marked on the bottle that is has 1036gm glycol p/L.

If it isn't that concentrated its watered down (to sell cheap) and makes it harder to mix. (working out the true glycol content you actually have)

If you get the concentrated stuff that is 1036gm/L you mix this at ratio of 33% concentrate to 67%water and its correct.

Link to comment
https://www.sau.com.au/forums/topic/126877-coolant/page/2/#findComment-2396322
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.  
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...