Jump to content
SAU Community

My New Stagea!

barge

By barge,
in Four Door Family & Wagoneers

 Share

Recommended Posts

barge Apprentice

barge

Posted
Posted

Howdy All

Just picked up my new fire engine red s2. I am seriously impressed with the power and driveability.

Was hoping you guys could help me out with a couple of things.

1. It looks like the previous owner must have disabled/removed the HID headlights as there are DIY wire joiners behined the bulbs. Is there any way to refit new HID bulbes, ballasts?

2. How do 18x 9.5 inch rims fit under rear gaurds? Was looking at

Manaray 18"

18x8.5 +46 5x114.3

18x9.5 +48 5x114.3

What do you think?

Car is dead stock ATM but am looking at doing a few low key mods in the near future.

Any help is appreciated.

Matt

Oh. I (and stagea) is located in Newcastle NSW

post-30657-1153976873.jpg

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/
Share on other sites
Tangles Grand Master

Tangles

Posted
Posted

Very very nice, well done.

Ive got a Series 1 so cant offer too much advice about the lights, however with the mags, you MUST run same width front and rear - or risk stuffing the 4wd system.

18 x 8.5inch width should be ok front and rear.

Best of luck with it all !

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362000
Share on other sites
barge Apprentice

barge

Posted
  • Author
Posted

Hey that was quick!

Cheers for the info. Ill have to try and find a matched set of rims.

One more question, does anyone know where I can get a hold of nissan central locking key fob? Car only came with one. Is there an aftermarket key that will do the job?

Also do S2's come factory with a 3 point imobiliser?

CHeers

Matt

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362024
Share on other sites
Tangles Grand Master

Tangles

Posted
Posted
I dont know, but any half decent alarm system should do the central locking as well.

Kid flushed ours down the toilet (still bloody blocked too).

So yeah, we lost 1 x car key and 1 x alarm keypad

bought a new keypad off ebay but need it calibrated some how, could do with a new key, too

Plus Im a cheapskate and didnt pay that $20 the fella wanted to wire up the alarm to the central locking !

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362039
Share on other sites
munchstagea Mentor

munchstagea

Posted
Posted

Hi Matt,

Nice work on the Stag!

You are going to need that 3 point alarm for insurance right? Well anything factory fitted won't cut it as far as I know, you will need a Black wired, 3 point immob, Aust standards approved alarm so don't worry about the standard key fob as you will have a new remote with the alarm and you can get more keys cut from a Patrol blank I hear...

Welcome and enjoy!

Cheers

Luke

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362053
Share on other sites
munchstagea Mentor

munchstagea

Posted
Posted
Plus Im a cheapskate and didnt pay that $20 the fella wanted to wire up the alarm to the central locking !

Haha! You crack me up Brendan!!!

What type of alarm is it? I have a mongoose and the instructions you may need to program it in...

Luke

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362064
Share on other sites
Tangles Grand Master

Tangles

Posted
Posted
Haha! You crack me up Brendan!!!

What type of alarm is it? I have a mongoose and the instructions you may need to program it in...

Luke

LOL

glad to be of service

ebay, $160 delivered, black wired full Australian insurance approved, called a Black Widow.

Ive got a new (cheap; ebay) keypad but I heard I had to go to Strathfield to get it coded correctly.

All in good time; probably go there and get them to throw in a DVD player (head unit only) to make it worth their while.

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362137
Share on other sites
Tangles Grand Master

Tangles

Posted
Posted
So you wont pay $20 to hook up the central locking, but several hundred for a dvd player just so you can get the keypad hooked up..... :(

thats right, as I'll sell the Clarion 180w tape head unit and 6stack Clarion CD player fo a cple hundred !

so a dvd player will cost me nothing, in essence.

anyone interested? I can assure you all that the CD player has never skipped and both units are in awesome condition. But for me 700mb isnt long enough - give me 3.7gig of pure trance, thanks !

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362260
Share on other sites
darrinspencer Grand Master

darrinspencer

Posted
Posted
1. It looks like the previous owner must have disabled/removed the HID headlights as there are DIY wire joiners behined the bulbs. Is there any way to refit new HID bulbes, ballasts?

2. How do 18x 9.5 inch rims fit under rear gaurds? Was looking at

Manaray 18"

18x8.5 +46 5x114.3

18x9.5 +48 5x114.3

Wheels

The other posts are correct for same width front and rear, but only if your car is a 4WD

If it is RWD, you can have different widths

The offsets you have quoted are wrong

Those wheels will sit too far in and most likely foul the suspension

You need something more like +35 on a 8.5 rim and 9.5 rim may just not fit

The biggest rim width most Stagea have on them are 9.0 +30 (33/34 GTR offset) and they run every close to sitting outside the guards

Headlights

These would have been zenon's from factory, but under compliance they have to be converted back to standard type bulbs. Unfortunitly you cannot convert the lights back to factory zenon bulbs, plus they are illegal.

Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362272
Share on other sites
Sydneykid Grand Master

Sydneykid

Posted
Posted (edited)

The ATTESSA doesn't care about width of wheels/tyres, the only thing that it cares about is the diameter. They have to be the same front and rear.

Mine has 17 X 9 X 30mm offset, standard R33GTR wheels with 245/40/17 tyres and they are JUST inside the rear guards at 1.25 degrees negative camber.

As you can see they are just legal (particularly the rear);

R33GTR_Wheels_340mm_along.jpg

:( cheers :(

PS; they don't rub, even with the race car on trailer towed behind

Edited by Sydneykid
Link to comment
https://www.sau.com.au/forums/topic/127805-my-new-stagea/#findComment-2362650
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • soviet_merlin
      Most women will agree that parking is the most taxing part of driving

      By soviet_merlin · Posted

      I'd be worried about having to parallel park a boat like that. Magnificent car though.
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      This car has run before on this z32 ecu can get the part number for you, I have tried with no AFM it didn’t change anything, I compression tested today 140-150 across all 6 cylinders, also set fuel pressure to 43psi. The only weird thing was cylinder 1 plug was black and fouled other 5 cylinders were just wet with fuel. Spun cas by hand and confirmed injectors are clicking 
    • MBS206
      new 1.5 LSD issues/concerns

      By MBS206 · Posted

      Since you came here to ask for help, have you thought about answering our questions, that might help us lead you to why it was skipping, or have you given up on getting advice?
    • GTSBoy
      new 1.5 LSD issues/concerns

      By GTSBoy · Posted

      A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • GTSBoy
      Boost cut after swap(RB25DET NEO) R34

      By GTSBoy · Posted

      The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
×
×
  • Create New...