Jump to content
SAU Community

Recommended Posts

have nissan rb20 motor,all the parts on it are for sale (not selling whole only in parts)

rb20det head $250

rb20det stock plenum $200 (the whole lot)

rb20det stock turbo and dump pipe $150 (had lettle play in it)

rb20det stock alt $100

rb20det Cooler with Piping (Only To Engine Bay) $80

rb20det throttle body $50

rb20det Exhaust mainfold $80

rb20det airconditioning pump $80

all other parts are for sale of the motor just ask

silvia two front lights one is broken $80

2 front seats drivers has rip no rails $100

pm or ring zack on 04025582378

iam in nelson bay 45 mins north from newcastle

or might swap for after market stuff for rb20 motor

some stuff i need ,afm,turbo timer,taco's,boost controller,cooler,and let me know if u have any thing else

I will listen to offers as long as they are reasonable.

all parts are Negotiable!!!!!!!!

post-26609-1154214914.jpg

post-26609-1154215015.jpg

post-26609-1154215130.jpg

post-26609-1154215270.jpg

post-26609-1154215345.jpg

post-26609-1154215602.jpg

Edited by 2bevil
Link to comment
https://www.sau.com.au/forums/topic/128113-rb20-motor-partssome-silvia-parts/
Share on other sites

'Jago'

where are u located = nelson bay 45mins north from newcastle

complete RB20 bottom end = the block has a crack in it so i dont think it would be any good but can sell u all the internal parts if u like

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Reading through the engine service manual their advice is do a cylinder balance test. Unplug one injector at a time and see if the idle drops a consistent RPM. You can also do this using a Consult cable which is easier. They also call for unplugging the power transistor, then with the engine off and the fuel rail unhooked from the manifold verifying that you have good fuel flow (even injection, no dripping/leaks, etc) when you twist the CAS by hand. Also verify the spark by pulling the spark plugs and allowing the plugs to ground and turning the CAS by hand. I would also start doing the sensor checks and idle valve checks in service manual. Make sure the MAF tests reasonably, the intake air regulator is sane, etc. You may have to get new spark plugs.
    • This sounds very old of me, however since buying the Tiguan shit box, my view on shit boxes have changed.
    • I've looked up the parts number (41011AL501). It's around $700 OEM. Usually our Infiniti G35 here in Canada have interchangeable parts with my Stagea but the parts number are not the same. I have looked around and it seems the JDM 2005 V35 Skyline (which is the same as our G35) has the same caliper but I cannot confirm. And I can't find a repair kit. The inner brake pads drags on the rotor, seems to be rusty piston. Thanks for the info by the way
    • This coupled with 6-9 speed autos with ridiculously short gearing is why these modern shitbox cars always seem so fast off the line. If it wasn't for those things, Raptors would not seem fast. The problem we have is there is a driveability gap between a more gentle take off and a wheelspinning sideways launch. The difference between ankle flex required to achieve one and ankle flex required to achieve the other is about 0.5°.
    • Yeah I think I'm also with the opposite here. It's 'hard to keep up with traffic' because in the real world I'm accelerating with 15% throttle and they are pinning it. It feels like I'm being an overt dickhead at anything above 15% throttle, so the car sounds like I'm being an overt dickhead to keep up with/get ahead of traffic when I'm really just trying to drive with traffic. There would be no issue 'keeping up with traffic' if we used the same level of throttle input/aggression to drive around. People really do just drive around with their foot nearly pinned in econoboxes.
×
×
  • Create New...