Jump to content
SAU Community

Recommended Posts

craz0, id check ur insurance contract, namely the details of disclosure. the wording will vary from company to company, but the gist is about as follows-

if u dont tell us about things which make ur car faster, more attractive toi thieves, illegal(according to your state laws, ie zorst, bov, rim size) then we dont pay fo your crash/theft etc.

the best thing u can do is make sure that

a: all your mods are legal

b: they are approved by the insurance coy

c: if not strictly legal, see if u can get them engineered to be so

d: the insurance ciy is informed of any and all mods

doing this will save a lot of hassle and possible heartache in the future, cause we dont want u to end up as another one of those 'the insurance company wouldnt pay when i wrote off my car cause my whels were an inch too wide' stories...

nb: faaaaaaaaaaaark! lucky cheap quoted bastard!!!

Originally posted by PranK

does she have mods now? :confused:

I have an exhaust now Prank :D

and a strut brace...and a pod! LOL

it all takes time...I've only had the car 2 years :bahaha: :bahaha:

As for Suncorp and mods, as far as i was aware they allow a certain amount, but not unlimited. Will have to pull out my booklet thingy and find out.

as for alarms...I have a Brant immobiliser/alarm noted on my policy but i didn't get a discount. They had a "Immobiliser Campaign" last year where you could recieve a discount, but the immobilisers had to be fitted by a CAR-SAFE approved installer, and Brant wasn't on their list unfortunately.

my r33 gtst is 850 per year with suncorp. It in my dads name as a rating 1, and when i spoke to them last, under all new policies, they will now no longer insure unlisted under 25s... again, thanks to boxhead :D

only killer with suncorp is excess. I think mines something like 2800 if I crash, compared to my 4wd of $300.

Originally posted by Boxhead

i just had a nice think about it, now...

last year as most of you know i went through a barbed wire fence...

now, lets say i wasnt insured.. it would have cost about 7800 all up, including me changing the front bar, and color which didnt need to be done,  

now people might say, i didnt damage much, but remember 90% of the car had to be resprayed because of the barbed wire..

so if i had that same crash, and same cost this year, and didnt have insurance, i have saved 800, on the premium, dont forget the excess which is 800 aswell..

now, the way i think of it best is to sorta insure yourself.. have a look at the premiums, and simply save that much over the year, or as quick as you can, and put in it an invester account, which you can access if need be, but it earns more money, and then same thing next year... but once you have the valued amount of your car, no more doing it. because a) your money will grow untill you take the money out.. and B) the worst you could do is right it off, costing you the amount you have saved...

paying half the cost of the car to insurance company is ludachrist.

boxhead

i recon thats a great idea. thats great thinking. if everyone started to do this then the insurance companies would wake up to them selves and start charging realistic prices.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...