Jump to content
SAU Community

Recommended Posts

I am after around 300 kw at the wheels and a turbo with as little lag as possible.

Is the HKS gtrs a good option for a r33 gtst or is there other for cheaper with the same or better power figures with as little lag.

I dont know much about turbos so any help would be very greatful.

Link to comment
https://www.sau.com.au/forums/topic/131576-hks-gt-rs/
Share on other sites

I am after around 300 kw at the wheels and a turbo with as little lag as possible.

Is the HKS gtrs a good option for a r33 gtst or is there other for cheaper with the same or better power figures with as little lag.

I dont know much about turbos so any help would be very greatful.

Depends on your mods, see the thread in the RB25 Sticky dyno results, this might help you. :D

Link to comment
https://www.sau.com.au/forums/topic/131576-hks-gt-rs/#findComment-2436314
Share on other sites

300rwkw and blistering response doesnt happen on an RB25.

You have to wait till around 4k... give or take a few hundred rpm.

If you search using "GT-RS" you will find a great deal of information as i linked half a dozen threads to a GT-RS question last week :)

cheers

Link to comment
https://www.sau.com.au/forums/topic/131576-hks-gt-rs/#findComment-2436471
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Despite the level up question, actually I do know what that is....it is a pressure sender wire.  So check out around the oil filter for an oil pressure sender, or maybe fuel pressure near the filter or on the engine. Possibly but less likely coolant pressure sensor because they tend to be combined temp/pressure senders if you have one. Could also be brake pressure (in a brake line somewhere pre ABS) but maybe I'm the only one that has that on a skyline.
    • Pull codes via the self-diagnosis procedure. As far as I can tell this is just a sign of transmission issues but not a code unto itself.
    • Hi All, putting the engine back together and everything is perfect except have this plug left over.. any ideas what it is for and where it goes? Is on cold side under the intake plenum *note not a stock plug, as everything has been modified Cheers
    • Sounds like a misfire. Check fuel pressure and don't even think about going into boost while it's like this unless you enjoy engine rebuilds.
    • Just. Gasping. Here. Just. Gasping.
×
×
  • Create New...