Jump to content
SAU Community

Wtb: Stock R32/r33 Gts-t Rim/s Or R32 Gtr Rims

AzzurrA

By AzzurrA,
in Classifieds

 Share

Recommended Posts

AzzurrA Grand Master

AzzurrA

Posted
Posted

Hi Guys/Girls

I just found out one of my R32 GTS-t rims has a slight buckle in it, and i was intending to use them for my track rims in about 2 weeks time.....

as such, i need a replacement rim fairly urgently... does anyone have one i can beg/borrow/buy?

Thanks,

Jason

--{TRYDIS}-- Community Regular

--{TRYDIS}--

Posted
Posted (edited)
Hi Guys/Girls

I just found out one of my R32 GTS-t rims has a slight buckle in it, and i was intending to use them for my track rims in about 2 weeks time.....

as such, i need a replacement rim fairly urgently... does anyone have one i can beg/borrow/buy?

Thanks,

Jason

i have some but im in sydney nsw i was gonna let ya borrow em but just realised ur in qld sorry buddy

Edited by --{TRYDIS}--
AzzurrA Grand Master

AzzurrA

Posted
  • Author
Posted

thanks for that... i put my tyres on the rims yesterday, and the tyre shop claims that they were able to balance most of it out (balanced to within 4 grams on the one with the buckle/hop and 1 or 0 grams on the rest... their acceptable tolerance is apparently 7 grams) so i will see how it goes i guess.....

 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • The Bogan
      NC MX5

      By The Bogan · Posted

      The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Komdotkom
      R32 Gtst - Track Car

      By Komdotkom · Posted

      Good luck on the weekend mate
    • Duncan
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Duncan · Posted

      Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Duncan
      New

      By Duncan · Posted

      Welcome to SAU, what are you looking at buying?
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...