Jump to content
SAU Community

200 Awkw

stagon

By stagon,
in Four Door Family & Wagoneers

 Share

Recommended Posts

stagon Apprentice

stagon

Posted
  • Author
Posted (edited)

on the dyno we were checking fuel ratios and up to was getting towards the lean side. 12.5 i think the reading was. i dont fully understand how it all works but i have told the bloke i dont want to boost it up and have a fast car that lasts a couple of months. my car dosn't feel frinnished at the moment. only feeling the pull of the turbo from 4000rpm onwards. mechanic wants to get it back on the dyno and check fuel rail pressure, timing etc to make sure car is running safe. he was talking about fuel cut defender and other stuff that is going to go on the stag. what is a SAFC and what does it do and how much does it cost because it sounds like i need one?!!??!!

Edited by stagon
Link to comment
https://www.sau.com.au/forums/topic/132124-200-awkw/page/2/#findComment-2544104
Share on other sites
pixel8r Mentor

pixel8r

Posted
Posted

I've got a GT30 turbo on my series 2 stag and have only recently got a 3" full turbo-back exhaust fitted and now the turbo hits full boost around 3000rpm or maybe even less. Really pulls nice and hard with almost no lag. Before I had the exhaust fitted the lag was very noticeable but now its only ever so slight. One reason is that the turbine now spins more free and another reason is that the engine breathes better and therefore builds revs quicker.

I'm getting a safc2 fitted this week. Basically they just sit between your air flow meter and your ecu and modify the voltage that the ecu sees - enabling you to accurately tune your Air/Fuel ratios. Instead of running rich or lean, the SAFC can correct the AFR graph so that you're running much safer and more economical. You will also see improved performance as a result of your car being more efficient.

Hope that helps. It does have limitations but provided your AFR's aren't too way out then you should have great results with it.

Personally I'd get one of these before a fuel cut defender. Probably depends how much boost you're planning to run.

Link to comment
https://www.sau.com.au/forums/topic/132124-200-awkw/page/2/#findComment-2545098
Share on other sites
fcruz3r Experienced

fcruz3r

Posted
Posted

this might sound real stupid at this stage...but what is a GT30 turbo? is this a stock turbo...if so..which car? is there an advantage of using the GT30 turbo over hi-flowing the stockie ...in terms of turbu efficiency and $$$

Link to comment
https://www.sau.com.au/forums/topic/132124-200-awkw/page/2/#findComment-2574355
Share on other sites
munchstagea Mentor

munchstagea

Posted
Posted
this might sound real stupid at this stage...but what is a GT30 turbo? is this a stock turbo...if so..which car? is there an advantage of using the GT30 turbo over hi-flowing the stockie ...in terms of turbu efficiency and $$$

Have a read through this topic should shed some light as to the possible advantages, disadvantages and what a GT30 is.

Cheers

Luke

Link to comment
https://www.sau.com.au/forums/topic/132124-200-awkw/page/2/#findComment-2574398
Share on other sites
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Kaptain
      R33 general questions

      By Kaptain · Posted

      Im not entirely sure exactly what or where its leaking from, he started to pull the boots to swap to my new tie rods + ends and it just vomited fluid, so he closed em up up, swapped the rod ends to the old rods and let me know so I can figure a solution out, im guessing its all origional as as I passed 103k miles earlier this year im sure its just in need of a full overhual/rebuild anyways.    If i could just yank it off and be good it wouldn't be an issue to ship it out and wait for the turnaround but the guy I work with doesnt really have space to keep my car for a week or two at a time, would rather drop it off and have a replacement ready to drop in
    • GTSBoy
      R33 general questions

      By GTSBoy · Posted

      What do you mean by "seals"? Internal hydraulic seals (ie, is it leaking PS fluid?) or the rack boots that close the rack onto the tie-rods? Because the former is a rebuild, and the latter is trivial that you or any nearby mechanic could do. Dunno about the cowl. Just buy what you think is required and get anything else you find/break afterwards. Wing? Dunno. Don't like R33s enough to pay attention to them. Mirror glass is just glass (on the surface that you want to polish). Go for it.
    • Kaptain
      R33 general questions

      By Kaptain · Posted

      Hello! Long time lurker, been using the forums to address concerns and questions from afar for a while but I've struggled to find some answers so I guess its about time I made an account and formally asked some more knowledgeable people, since finding local skyline owners is hard (and shops that are knowledgeable or trustworthy to work on 'rare' cars are non existent out where im at, as skylines are quite uncommon to find in the wild around here). So the main 3 questions I have, 1: Steering rack has blown seals, well.. they kind of hold but they are not sealed properly anymore and as my R33 is my DD, i cant exactly rip the rack out and send it off or attempt to fix myself. As most refurb ones are around $1,100 or more shipped, and I have other things I need to work on around the car, I was seeking clarification on whether an S15 rack will more or less bolt right in, and whether a common mechanic could do any other required work to get it to fit. I ask, as I've found a supplier than can sell a manufactured as oem one for around 400, if not I'll likely order a used one from Jacks JDM, and take a risk on the seals there. The second question i have is that im replacing the front wiper cowl and have planned to buy 4 new clips and a new center clip but wasnt sure if there were any other clips that would also need to get replaced while I was at it. Given im sure any that are there now will simply break when I remove the old cowl... Last thing would be a fairly straight forward question, i think. If I manage (strong if, finding one has proven to be a pain) to find a R33 GTR spoiler/wing will it require much modification to bolt to a S2 R33 GTST? I've read the bolt patterns dont match but otherwise would bolt in, only options I have found with much luck is China stuff on ebay and carbonetics, which has a nice $650 shipping fee... so if anyone has any pointers where a US chap could locate one that would be great Random side question as well, the mirrors as I understand are mirror glass, and as im planning to polish my windows from water spots and surface scratches, i was hopeful cerium oxide would be fine for them too, as my research points to, but clarification is always nice. Any pointers would be appreciated, and while I have scoured the internet for answers if I missed a prior post somewhere that may answer these directly please point me towards it, as i must have simply missed it. I have seen a post here or there that has mentioned it, but I usually get 50-50 answers, or half answers... I dont have a lot of fab experience or mechanic experience, outside of hydraulic and pneumatic stuff I did in the military and with how hard it is to source stuff in the US, id rather not wing it and hemmoraghe money lol. Thanks guys! Sorry for the monumental first post haha
    • AdiR34
      Did tie rods. Steering now not "springing" back.

      By AdiR34 · Posted

      Yep, there's a very minor drift left that happens a few seconds after letting go of the steering wheel, but not enough to bother me. Enjoying the car still!
    • Keeper
      S A U N S W Club Membership

      By Keeper · Posted

      Got you mate. Check your email!
×
×
  • Create New...