Jump to content
SAU Community

Recommended Posts

Hi All,

Just purchased my my first Skyline. A Series II R33 GTS-T (1997). It appears to have a factory turbo timer. Is this the case or has an aftermarket one been in fitted??

Also there has been the odd occasion when it has not operated at all...

Cheers

Link to comment
https://www.sau.com.au/forums/topic/132211-r33-turbo-timer/
Share on other sites

  • 2 weeks later...

check under the steering column, theres a big gap there and an easy place to wire one up, then check behind the middle of your dash, behind the head unit, and if then no luck (in some circumstances) you could have an aftermarket ecu in it which could be running this function, happened to my mates rx7 series 4.

cheers :O

Link to comment
https://www.sau.com.au/forums/topic/132211-r33-turbo-timer/#findComment-2492731
Share on other sites

an easy way to find it is take your handbrake cover off, find the wire connected to it that enables the turbo timer (it will be the only wire there), and trace it. :)

cheers

Thanks mate

Much appreciated

Link to comment
https://www.sau.com.au/forums/topic/132211-r33-turbo-timer/#findComment-2493497
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hard to say, just pop the rocker covers off and have a look if you think it's cammed. You probably need to replace the valve cover gasket/half moons anyways.
    • From my youth: GTi-R clutch change is a massive pain. The gearboxes are fragile? But the car is super cool and I want one 😢 
    • Remember this is 1988 tech.
    • Driveline vibration is resolved. I ended up loosening all my engine mount and trans mount bolts, giving it a good shake then retightening everything and it's gone... Let's just say I was surprised that fixed it.  I've been happily driving it around again but unfortunately put zero time into my direct port/constant pressure WMI setup. I'm on vacation next week, so I'll try and finalize it then.  On a different note, I spent all week fuel/ignition mapping 2x 216L V16 engines. Turbo's were burning glycol and we swapped them out for larger units. We also had planned emissions testing on site, so I figured I'd be there the same week to use their instrumentation and massage any emissions issues out if needed. This was a first for me. Fuel management is similar in certain ways to automotive (i.e air density as load variable) but very different in others. It's all PLC based and AFR's are controlled by air and not fuel. They use a control valve between the turbo and air manifold to control pressure which in turn controls AFR's. Due to this, target AFR tables supplied by the OEM are in pressures and not mass which really through me off. They use air pressure vs fuel pressure tables. I also relied on an O2 concentration sensor the emissions team had in the exhaust. Ignition timing was also all over the place and we were losing a fair bit of power. They're now happily sitting at 16-40BTDC depending on load. We were making about 1600kw at 900rpm at 90% load. Engines were running a lot smoother as well.    
    • heh, aint no R32 ever meeting modern targa cage rules unless the driver is veeeery short OP, good luck with the sale, since its already in the land of freedom I'm sure you will find a good buyer.
×
×
  • Create New...