Jump to content
SAU Community

Recommended Posts

Time to get my water pump changed on my r32 gtr. I'm thinking about paying extra and getting the N1 waterpump installed as a good upgrade. However i've been told by a respectable tuner that the N1's would not work very well under normal driving conditions (in traffic, in the middle of an aussie summer with the airconditioning cranked up) and might cause problems. Apparently i've heard that the N1 water pumps only works well under high Rev's for long durations. Can anyone clarify this for me?

Link to comment
https://www.sau.com.au/forums/topic/135325-r32-gtr-n1-water-pump-vs-standard/
Share on other sites

Heres the 2 side by side:

n1waterpump.jpg

Your tuner is right in saying N1 pumps don't flow as much as standard in normal driving conditions. If the revs are higher then the quantity of water pumping through the system is not bottlenecked as the standard one would be moreso.

mines upgraded to n1 and never had issues with overheating when cruisin around under 4000rpm for over 1200km or so. must admit it hasnt been 40 degree weather though so that will be a test. didnt move 1 degree on the dyno for a 4-5 hour tune session with various loads on the engine so it seems to be fine.

just my 2c worth :(

Mines N1, never seen the water temp go up over normal, even when thrashing it in really hot weather, also in traffic when i use it as a daily, even with ac on, there's no issues

Some will argue with that, but ive never had a problem with the water temp :(

Hope that helps

Thought i'd add this in for future reference incase anyone searches the forums regarding this topic. I've confirmed these few details with a few mechanics who specialize in GTR's:

The real difference between the N1 pumps and standard pumps is the N1 pumps stop cavitation at higher RPM's. One tuner mentioned he had standard GTR water pump on his 680HP GTR without any adverse effects. People with high HP track cars doing endurance runs (holding revs over 5000+ rpms for a good period of time) will see real benefits from a N1 pump. The standard gtr water pump is around AU$189, the N1 is about AU$400. Physically the N1 has a bigger 6 fin arrangement (see pic above) and an extra hole (apparently) the standard GTR pump has a smaller 8 fin arrangement. From my own experience, street driving with the standard pump vs the N1, I've seen no real increase in cooling performance with the N1, its still the almost same as standard. Bear in mind I dont push my car hard at all. I suppose I'll take solice in the fact that if I belt it hard, my water pump wont go :angry:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...