Jump to content
SAU Community

Recommended Posts

Howdy everyone

I currently drive a R32 GTR with only mild work done to it - they being R34 BB turbos, high-flow filter and turbo-back exhaust. I run .9 Bar in stock config with no boost controller. What power should i expect to be putting out, awKW/awHP? what tourque range? Also, with R34 turbo's what could I safely boost up to?

Thanks

Ian

Link to comment
https://www.sau.com.au/forums/topic/139358-a-few-questions/
Share on other sites

Depends..........a 1.3Bar is safe if you have replaced oil pump and timing belt, and provided you have a good tune.

Lots of factors come into play when asking whats safe.

As far as what I have seen on this site and power levels you should be getting on a standard

computer is around 200Kws at all 4 with your mods.Upping the boost 1.3 Bar will give you

230Kws or so.

PFC with a safe tune will push both those figures by around 20Kws. :D

Are you sure they are BB....as paul has said.....1Bar max if they are ceramic and not bb.

Link to comment
https://www.sau.com.au/forums/topic/139358-a-few-questions/#findComment-2596827
Share on other sites

... how does and oil pump & timing belt change = 1.3bar & safe?

Cause it doesnt!

R34 stockers ARE ball bearing... and still retain a ceramic wheel.

If the are R34 stock turbos, 240rwkw give or take

If they are R34 N1's (steel rear), 300-330rwkw.

You really need to find out what turbos are on there

Link to comment
https://www.sau.com.au/forums/topic/139358-a-few-questions/#findComment-2596910
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...