Jump to content
SAU Community

Recommended Posts

i have one sr20de engine vvt out off s14 $800 has loom,airflow meter,ecu,flywheel,clutch,dumppipe has done aorund 55000kms

r34 front bar nismo has small cracks at bottem white 300 aslo have gtt wing sold!, r34gtr rear bar to suite gtt may need lil work to fit other wise goes on good is plastic bar 350 standed r34gtt nismo skirts sold!

vic melb 0408-569-537

Link to comment
https://www.sau.com.au/forums/topic/147241-r34-parts-n-sr20de/
Share on other sites

heres some pics

till i get more

post-16424-1166320605.jpg

post-16424-1166320426.jpg

3 small cracks in bottem of bar can harldy see them onely one stands out

excuse the black lines on bar was were i was going 2 cut out for cooler

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...