Jump to content
SAU Community

Recommended Posts

Hi Guys,

Some MFKKer broke into my GTR the other day and had a good go at stealing it.

Fortunately my alarm installer was more intelligent than the apes that broke in and all they managed to do was bust up the bottom of my dash and steal my badges.

Anyway, I've got someone coming to fix the wiring, but I need some advice on getting replacements for the other broken bits on the dash.

As far as I can tell, I just need 3 pieces:

1 - the entire piece that runs under the steering wheel from the door to the centre console.

2 - the smaller piece of the plastic surround for the steering wheel (bottom part), that also has the hole for the lock barrel

3 - the lock barrel itself (was hammered off)

Can someone give me some advice on where to get these parts the cheapest?

Are the GTR parts the same as the cheaper models (GTST etc)?

I also may as well replace the driver door trim where the window controls are since it's a bit worn. Hopefully this is also standard on the R33.

Pics below:

(alarm module blurred for security)

post-2242-1166011455.jpgpost-2242-1166010254.jpgpost-2242-1166010265.jpgpost-2242-1166012166.jpg

Thanks!!

Edited by azaram

BTW... the main thing I'm after is for someone to verify that these interior parts off a standard R33 will fit onto my R33 GTR.

I've looked through the gallery and they look the same, but I need to know for sure if they'll fit the GTR before I buy them.

I think you might be lucky the GTS-t parts will probably suit.

As for the driver side window switch panel. You can get one brand new from Nissan for the $75 - $85 mark. Let me know if you want one i can tell you who/where to call etc.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...