Jump to content
SAU Community

Recommended Posts

hey everyone. i have got a 32 GTR and i just got a 33 GTR motor complete. i rang a few people and they say they SHOULD be the same(wiring). My mechanic just had a quick look and he thought the wiring (plugs) were different. Has anyone done this conversion, and come across any problems?

cheers scott

Edited by scotty_gtr
Link to comment
https://www.sau.com.au/forums/topic/148564-33gtr-motor-in-32gtr/
Share on other sites

  • 2 weeks later...

hey guys, im new to the skyline scene, i was jsut wondering, what are the specific differences to the motors from different models? being like 32,33,34? different castings? are they the same layout to do with headbolts? i dont even know where to start, are they just asthetically different? with the main structure, casting being the same?

any info would be greatly appreciated

regards

Lionel

afaik, there isnt a huge difference across the range.

i know the R32 engine had some oil drainage/supply issues.

couldnt tell you if there are other differences though, its probably been covered a few times though, try searching.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...