Jump to content
SAU Community

Recommended Posts

Hmmm, difference between the GTS and the GTR...

Think about the biggest difference possible, that is what it was like! :lol:

The GTS felt like it took years to get to 100, in the GTR you put your foot down in 1st, change to 2nd and what do you know 100!!!

It's such a big difference, it's hard to explain but it's major...

Link to comment
https://www.sau.com.au/forums/topic/15-god-damn/page/4/#findComment-314
Share on other sites

Prank,

The same thing happened 2 me a few months ago. The rear bumper and exhaust were F***ed, but it didnt look so bad

Turns out the wole exhaust needed replacing, the rear diff and HICAS were serviced, and new rear bar. about $5000 woth of damage which their insurance covered. I almost didnt get their details because the damage didnt look so bad and they offered to pay me $800 cash for damages.

The point is there is more than meets the eye. Make sure the repairer checks everything.

If Ur girlfriend still feels bad about the accident, take her shoe shopping. That'll cheer her up :P

Link to comment
https://www.sau.com.au/forums/topic/15-god-damn/page/4/#findComment-323
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...