Jump to content
SAU Community

Recommended Posts

My turbo is screaming when it reaches the set boost level.

Makes normal spool up sound while getting there but makes a horrible sound on full boost.

I've varied boost from 10psi to 18psi and the sound is only there when it has reached this level.

Power has not been lost, oil pressure/level and quality are good.

A local workshop suggested that the shaft bearing may be loose or worn and the exhaust wheel is touching the housing????? Either that or it's a blockage in the oil feed line and the noise is from the bearings running dry.

To anyone with knowledge does that sound right or should my turbo have blown up by now???

Could it be something to do with air getting in or out of somewhere it aint supposed to?

The Turbo is an old HKS T3G with an internal wastegate.

Link to comment
https://www.sau.com.au/forums/topic/15227-screaming-on-boost/
Share on other sites

yeah happened to me and it ended up losing boost and the flow out the end stopped.

i just high flowed the trurbo and it works fine now

but there was not much movment inside the turbo and it looked fine from outside.

but get it looked at and rebuilt.... but do it before u start losing boost. cos it wil happen if the same prob as mine

at first it would only happen at high boost but then slowly worked it way down and then boost would come down with it.

cheers

Thanks to all for your replies.

Doesn't sound good. This may be the start of some serious rebuilding.

It's definately not a belt. Time to rip the Turbo off I guess. Maybe I'll find out now what a HKS T3G is. I now it's been good for over 200 rwkw so a bit of rebuilding might see more.

Cheers fellas

Could it be your exhaust manifold. Mine schreeches at 6,000 rpm (not bad) just noisy. The guy's said some manifolds come lose after time, so the air escapes and makes that noise.

It might not be the problem, but it's one to keep in mind....

Cheers

Loz

Lozza150's right on the ball. The screaming noise you're hearing is air escaping from between either the exhaust manifold and the block or the exhaust manifold and the turbo. My car did the same thing, you'll probably need to unbolt it, replace the gasket and re-bolt it back up.

Cheers,

matt

Adam,

Yeah but his car doesn't seem to have any problems making boost, which would indicate that there isn't any damage to the turbo...

I've had a busted thrust bearing on a different turbo which caused the compressor wheel to grind itself into the housing... This didn't even make any noise, the car just wouldn't make the same amount of boost!

matt

I agree that it sounds like an exhaust gas leak, a friends VL turbo made a similar noise, he took it to a so called turbo mechanic who said it's rebuild time, before that he thought he'd check it over himself and discovered that the bolts from the turbo to the manifold were loose, I believe the turbo shop would have thought that all along and would have recieved $800+ for simply tightening a few bolts.

the worst part is most of the cost is to take off all the bits to get to the manifold.... you may as well Hi flow or rebuild the turbo while it's off.

Well that's what I'd do... Hence why i'm not going to fix the exhaust leak till i can afford to hi flow the stock turbo...or fit a HKS gt2540.... (Yeah right)

Loz

Cheers again for your replies. I believe it is more along the lines of a gasket leak too.

I'll have a good look Saturday and post back what I find for any other people curious.

By the way my Turbo aint stock and I don't think HKS would approve of someone going to their handy work with an air grinder.

A rebuild maybe, but if it comes off I'm hoping it can go straight back on again.

I'm getting really toey running around town without letting it build any boost.

The slightest hint of waistgate chatter is enough to get me going. ch ch ch ch ch to to tooo.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to it's full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so damn hot in there, that made it all the more easy to remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. I was standing there looking at the car and said 'f**k it'. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...