Jump to content
SAU Community

Recommended Posts

  • Replies 80
  • Created
  • Last Reply

Top Posters In This Topic

nice burnout!!

what about the run? howd u guys go?

The oil return pipe touched the rear housing which was glowing and smoked cause of the oil

Then when i come back out to run

They told me come back at a national meet

the cars not a street car bla bla bla

and i couldnt argue as they`ll kick me out

but its engineered and emission tested so

This is the run on 18 psi no nitrous

Some of the tuning

Link to comment
https://www.sau.com.au/forums/topic/152343-lnemup/#findComment-2834374
Share on other sites

please no need for that sort of reply

Doesn't come across very professional when this thread is really about promoting the new name of your shop :P

ohhhh Come on donkey man

whats wrong 2day change of attuide is there

have you hurt your head

So do you like the clips or not (shibby)

Ps its my Fathers Shop

Edited by MR331307
Link to comment
https://www.sau.com.au/forums/topic/152343-lnemup/#findComment-2836551
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...