Jump to content
SAU Community

Recommended Posts

Has anyone installed 6" component speakers in a R34, i am currently doing my whole new system and decided to put the components in the back as there is no room up the front for all the parts, does anyone have pics of work they have done or had done?

Also nissan have made a damn good car except the fact that i haven't stopped swearing since i started this project cause nothing lines up with the stock system.

-----------------remember smoke tyres not drugs-----------------

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/
Share on other sites

just took the whole rear parcel shelf out so could get to speakers then found that the plastic cover over speakers has srews holding them on which you can access through some holes through the boot below the shelf, would of been handy to be able to see them first up, the shelf just clips through to the boot and also under the overlap behind rear seats, also to get my clarions in had to drill out the existing holes to fit new configuration.

i mean really it's not that hard if ya think about it hoo hah ( except for all the swearing)

----------------remember smoke tyres not drugs--------------

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2855693
Share on other sites

directly underneath the speakers in the boot there should be a lot of holes in the sheetmetal i'm not sure what ones but there should be four on each side that go th the screws, really hard to see that's why i pulled the whole parcel shelf out it's much easier, there should be two blue clips in the boot and three inside the car behind the rear headrest plus you have to take the 3 bolts out that are for the baby harness points to get the shelf out. hope that helps

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2855770
Share on other sites

there are two bolts holding the bottom part of the seat, remove tht. Then just take out the bottom piece seat and the rear there are two bolts as well at both sides, undo those, then lift the back piece as it is hooked on to the frame behind..quite a hassle because they don't fold down :cheers:

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2855971
Share on other sites

nice work r34-gtt not that hard once you get it off and see whats going on under there. have my speakers in as well and just fitted the components box and tweeters to the back shelf as well so i'll post pics when it's all back together.

-------------------remember smoke tyres not drugs---------------

Link to comment
https://www.sau.com.au/forums/topic/153481-r34-system/#findComment-2856781
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Agreed, I've never seen a 260RS specific manual. As GTSBoy said it will mostly be stagea other than the engine loom https://www.hgeconsulting.com.au/stageaservicemanual.pdf
    • You'lll likely have to make do with R33 GTR for engine/tranny stuff, and Stagea for the body. I don't know that there's even been an actual diagram seen in the wild.
    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
×
×
  • Create New...