Jump to content
SAU Community

Fuel Cut? Plz Help

R33silverS2

By R33silverS2,
in Engines & Forced Induction

 Share

Recommended Posts

R33silverS2 Mentor

R33silverS2

Posted
Posted

Ok I am not reffering to the rich and retard mode which gives you the power dip, but rather a violent cut / stop when on WOT. I had my SAFCII dyno tuned and when i first drove the car all was fine. WOT 11psi all good. Then later that night i went to give it a squirt in second and as the boost pushed 11 and was on the increase, usually gets to about 12 for a bit then drops back down, the car violently cut out and felt like the brakes had been slammed on. :(

I have done heaps of searching on fuel / boost cuts and rich and reatrd etc but I have only now experienced theis problem after i got my SAFCII installed and tuned. :D Before the SAFCII the car could go to around 1 bar without this violent cut business. Over 11 it would usually expereince the reatarding and richening up of mixtures but never cut out like that. Anyone know why this is happening now with the safcII??? IT was quite cold outside but the boost certainly didn't get over 12psi, and it did it in 2nd and forth - feels terrible! Ideas's Comments??

Thanks

Link to comment
https://www.sau.com.au/forums/topic/154318-fuel-cut-plz-help/
Share on other sites
R33silverS2 Mentor

R33silverS2

Posted
  • Author
Posted

Does anyone think that it could be another component causing the problem that just coincidently happened after the safcII tune, 2 hrs hard reving on the dyno etc??? Coil packs?? or would it defienately be a fuel cut. Basically feels like someone slams the brakes on for a sec and if you arn't wearing a seatbelt you would fly forward..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Rezz
      R35 GT-R production ends after 18 years

      By Rezz · Posted

      Order for the 2025 model R35 GT-R were accepted from 3rd March and 26th August the last order rolled off the production line at the Tochigi plant. Concerning the R35 GT-R replacement, current Nissan CEO Ivan Espinosa said "Nothing has been decided about the GT-R at this time, but we are well aware that everyone is waiting. The GT-R will evolve and reappear in the future. Please be patient until that day comes." Nissan has a lot of issues with management and finances so take Espinosa's words with a big grain of salt. From what discussions I've had and read about here in Japan, not a lot of people are confident about Nissan's future, let alone the next GT-R. 
    • Kapr
      ECU sees many times the speed than speedo does (R34 swap)

      By Kapr · Posted

      Thanks. We getting some parts along too so he will be solving the speed issue like next week so i will let you know what he came up with.   
    • MBS206
      R34 25GT Engine Light 21

      By MBS206 · Posted

      21 is explicitly the coils detected as the issue. Is it guaranteed the actual issue? No. Just the ECU thinks it is. When you say rattling, describe it better, get an audio clip as best you can if possible.
    • CF.Panda
      R34 25GT Engine Light 21

      By CF.Panda · Posted

      Yea got me coppers. Bad news is I just put them in and the car still has the light and shakes. I also noticed I hear like rattling coming from the exhaust piping right under me. Does 21 also have a possibility of being O2 sensors?   So, coil packs are good, the harness is good, the MAF is working, and obviously the spark plugs just replaced and working.
    • MBS206
      RB25DE NEO with Haltech ECU

      By MBS206 · Posted

      Make sure you drop the GTT base tune back in, and set your injectors again, this will remove anything playing up with it you may have removed. Possibly lean there as it's normally a fast transient going THROUGH atmospheric pressure, and a turbo motor would then quickly go richer as boost builds. The only worry you MIGHT have is ignition timing, as the DE is higher compression than the DET from memory. But again, you're not in boost, so the DE motor will be a lot more forgiving at atmospheric.   Get Murray, Kinkstahs, and Johnny's input on tuning haltechs, those guys have played with tuning enough in the past to be able to help now you're past the trouble shooting stage of the MAP issue
×
×
  • Create New...