Jump to content
SAU Community

Recommended Posts

all depeends but here is a pic of the piping in my 33. i use the standard side pipe for the intake side and then a cross over pipe into the plenum.

might be just easier to get a new set of piping, there is a guy in hoppers that will sell u a set of polished aluminum piping for like $150 i think. i paid 400 for my cooler and piping but then upgraded cooler from a friend who smashed his sky and basically gave me his cooler b4 insurance saw it. lol.

if ur after the piping, the company is called GK Technologies

post-31466-1173665971.jpg

post-31466-1173666041.jpg

Edited by cheez
Link to comment
https://www.sau.com.au/forums/topic/160016-fmic/#findComment-2971229
Share on other sites

Well I just had an R33 FMIC kit put into my 32, the only problem was the pipe that goes in front of the fan was too big so it was rubbing against the bonnet and hitting the fan, so had it modified and it fits fine. Shouldn't be to hard going from a 32 to a 33 kit only the piping going into the plenum may need some minor mods.

Link to comment
https://www.sau.com.au/forums/topic/160016-fmic/#findComment-2971377
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...