Jump to content
SAU Community

Rb26 Naprec Valves

Fitzpatrick Speed Works
 Share

Recommended Posts

Fitzpatrick Speed Works Mentor

Fitzpatrick Speed Works

Posted
Posted

I have a set of brand new never used NAPREC big valves for a RB26. These valves are 1.5mm oversize however don't require new seat location just a radius and new seats to be cut. A must have when chasing big hp, on my own flow bench increasing the valve seat curtan area buy 1.5mm allowed 10cfm more on the inlet and 17cfm on the exhaust. (these test where run a 10.5 inches of water)

Although these are mentioned on websites for sale I never managed to ever get anywhere waiting for a response and hired a translator to ring Japan and special order these for me.

They are of the highest quality, as mentioned a great assett in a high hp and serious engine build, a mod that will net you genuine power gains.

Asking $600 plus freight for the the full set of Inlet and Exhaust.

Cheers

parts_b09.jpg

Link to comment
https://www.sau.com.au/forums/topic/161471-rb26-naprec-valves/
Share on other sites
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      Lock up the old for sale / wtb threads.

      By Duncan · Posted

      Ha, I've never pressed the X in all these years incase it removed the notification for all Admins
    • Duncan
      Blue/grey smoke after idle

      By Duncan · Posted

      I don't know, I've never done it that way, but 1. While it is an interference engine, there is still clearance between the valves and the piston at all points in the regular timing cycle 2. There is not a lot of distance before you can't catch the top of the valve stem any more I don't know if 2 is greater or less than 1. But 3. If it doesn't work out you are f**ked, engine is coming out to disassemble so it is a big bet.
    • Duncan
      Unpeeling the Orange

      By Duncan · Posted

      Semi slicks are horrible for road use, just use a high performance road tyre unless you really need the maximum grip. Noisy, unpredictable (amazing, until they are not), expensive due to very high wear and not good in cold and particular wet. And yes, it is a thing to store cars on stands instead of tyres if you know they are going to be parked up long term.....but who ever realises that a short park is going to stretch into years before it is out again!
    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      I know in Australia you'll definitely get above 30c. Parked in the shade in Summer you'll be above that. 😛 But in cooler climates, you might get that warm driving on the highway for a bit, but you'd never get to full heat temp. I'll try and find some of my historical tyre temps between Aus summer and winter (be aware immin the warmer area of Aus too.)
    • sunsetR33
      Blue/grey smoke after idle

      By sunsetR33 · Posted

      I get that taking off the head is best but that's a bit much for "just" valve seals. I was just under the impression that one would be able to rotate to TDC and be able to temporarily drop the valve without losing it and effectively having to remove the head to then recover it. I never knew people actually pushed rope into the cylinder to do valve seals hahaha So just to confirm, just going to TDC will not work? In that case I know when I do valve seals I'll maybe just remove the head and do some other things while I'm there, or just wait until I do an engine build.
×
×
  • Create New...