Jump to content
SAU Community

Recommended Posts

A small question for the wise and experienced of you out there.

It looks as if I have finally found a tidy Skyline to be my new wheels.

As I am new to turbo engines, I have tried to listen to all of the wise words spoken on here. :P

I am going to arrange a compression test before parting with my cash. Can anyone tell me what sort of compression numbers a stock R33 GTS-T engine from 94 should produce??

I realise they should all ideally be the same or very close to each other, but as a guide can anyone tell me what values I should see??

Cheers.

D.

Link to comment
https://www.sau.com.au/forums/topic/16323-r33-gts-t-compression-test-values/
Share on other sites

Units = MPa/rpm

RB25DE

Standard Value - 1.26/300

Limit Value - 0.96/300

RB25DET

Standard Value - 1.20/300

Limit Value- 0.90/300

RB26DETT

Standard Value - 1.18/300

Limit Value - 0.88/300

Varience limit between cylinders - 0.10/300 all above angines.

* Values from the Nissan Service Manual.

Get a cylinder leakage test.

Will give a better indication of engine cond.

Have had an engine recently that had acceptable compression variance but the leakage was up to 70% on 2 cylinders.

cheers

ken

As far as i understand it, it involves pumping compressed air into each cylinder at TDC and measuring the amount of air thats bled off as a result of leakage through either piston rings, valves or head gasket. This provides a true full load compression test and can more accurately guage ring wear in particular.

Red17

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Kinkstah, no, coilovers aren't illegal, especially as a bolt straight in. The illegal part will be if they're altering suspension geometry beyond factory limits, or the ride height is not legal.   Sounds like the blue slipper just didn't want to deal with any later possibility of mods appearing on the car.
    • The problem has always been that coilovers are able to be adjusted, almost at any time, to be too low. Most people who ever get/got defected for/with coilovers were actually afoul of the minimum ride height rule. So the interpretation by cops/inspectors was always that it is pointless to allow numpty to raise his coilovers and get the car inspected/cleared, then just drop them back down again as soon as they get around the corner from the inspection station.  This led to the interpretation that they were illegal unless rendered such that they can't be adjusted (ie, collars welded to the body, that sort of thing). That may or may not have ever actually been the official line, but I'm pretty sure it's not considered to be a solution these days. Coilovers themselves fall under clause 3.2 b of that manual, because they are an "installation of a variable ride height system" and they don't fit the exclusions in that clause (which point to air springs and other pneumatic adjusters). So, as per previous statements, they require engineering cert to be legal on the road. Once you have such cert, provided you do not adjust them outside the height range covered by the cert, you are OK. Without, you have an unroadworthy vehicle.
    • Here E10 is the cheapest fuel. And general advice is to not use it unless you hate your car. From what I remember it clogs up stuff in the fuel system or injectors?  With US/Canada being E10 across the board, does that mean that all fuel there is terrible?
    • Sorry, are coilovers ACTUALLY ILLEGAL in NSW? They aren't in Vic, as long as they retain 70% of stock travel and the car is above 100mm off the ground. Does NSW actually have a law making coilovers actually illegal? RWC/Blue Slip/Engineering people not knowing the actual f**king laws boils my blood. Demand them to point to the documentation that states a coilover is illegal. (it may exist in NSW ) Edit: I checked. They aren't. https://www.nsw.gov.au/sites/default/files/2021-02/RMS-infosheet-light-vehicle-modifications-manual-suspension-and-ride-height.pdf
×
×
  • Create New...