Jump to content
SAU Community

Recommended Posts

Just checking if anyone has ever hit their speed limiter in an R33, and what it's like (harsh or gentle). I have been track racing and been getting very close to the 180km/h and wondering how it feels when it kicks in.

And yeah, I know how to disconnect it, just wondering if it's worth doing.

Thanks

D

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/
Share on other sites

there is a wire which u can cut apparently or put a switch in its place. I dont think its worth it unless u are gettin to top speed where u can go more. I just reach under 180 at ippy raceway i dont think ill reach much more but it might be worth doing :P if u want to go fast lol

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-362764
Share on other sites

if you can find a wiring diagram of the computer, its wire number 53!!

The speed limiter is soft, and it appears more closer to 195kph on the speedo. The stock speedo is way out when going that fast.

I have checked it against my RSM.

A switch is the way to go, but not essential. I have had mine up to 240kph so far now...... open road

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-364792
Share on other sites

i've hit my speed limiter before. the car just suddenly nose dives due to the lack of acceleration, but once it drops below 180, it picks up again, and keeps doing this. when i hit it, i just back right off...doesn't feel as harsh as rev limiter, but maybe cos rev limiter's hit in the lower gears.

no such problems now with the power fc

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-368112
Share on other sites

I suppose that disconnecting it would be cool but given the recent news over the haul by police on hooning and the results they have had over the long weekend, in the interests of keeping your car etc. is it possible to disable it for racing and then put it back on for street driving. It appears that cutting a wire seems permanent and was wondering if there is a way of having it so that it can be turned on and off.....anyone know if this is possible?

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-370923
Share on other sites

I can't see the point of having a switch for street and track... No matter where you are (except NT) whether you're doing 175kph or 185kph, you're still doing a bit over the limit :D... It's not like your speed can sneak up on you that high :-)

I have no speed limiter (and the wire 53 isn't cut - interesting, eh...)...

As CMS Drifter said, just install a switch... Dick smith stock them, and they're pretty easy to fit :-)

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-372834
Share on other sites

Its not soo much in relation to how fast the speed catches up with you...rather if you modify your car (eg. take the speed limiter off) and are involved in an accident, even if you pay insurance the insurer may refuse to cover you. This may depend on whether you inform your insurer of the modifications made to the mechanics of the car..which im guessing they would need to / or should know about given how anal they are about items fixed to your car.

Furthermore charges could be applied should you be deemed to have modified the car to an extent that it is unroadworthy and hence driving an unroadworthy and unregistered vehicle which is an offence.

Nevertheless, each to their own....was just something of interest sake i guess more than anything.

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-372962
Share on other sites

Just checking if anyone has ever hit their speed limiter in an R33, and what it's like (harsh or gentle).

yes, your accelerating and all of a sudden you feel the engine stop reving and it feels like you slipped in the clutch it isnt rough or anything, and when you take you foot off the accelerator and the speed srops again you put your foot back on the pedal and it accelerates again :P

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-374110
Share on other sites

"i seriously doubt that any insurance company would go to that extent to prove that it was unroad worthy"

Be careful of that one mate....if an insurance company wants to get out of paying on a claim they will.....seen it often...i work in personal injury (mva etc) and they are harsh. Once the insurer was finished with you....then come the cops...who knows...

Just food for thought really. Just dont want people paying hundreds and hundreds of dollars in insurance and then find that they have made alterations which makes the policy invalid. I guess its best to let them know and find out now if your covered with the "slight" changes rather than getting a nasty shock when you make a claim after a crash.

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-374136
Share on other sites

my car doesnt have a speed limter due to aftermarket ecu... however, if you were to cut the wire the insurance company couldnt not pay out... as it is still road worthy. Prove me wrong and post any ADR's / legislation etc that says a car has to be limited to 180km.

another note is... i wouldnt just cut wire 53. There is a reason why greddy, hks, tomei make speed limit removers... that wire into both wire 53, 59, ground and +..

Link to comment
https://www.sau.com.au/forums/topic/17524-r33-speed-limiter/#findComment-381062
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...