Jump to content
SAU Community

Recommended Posts

i have a Tick noice that comes on for about 6 seconds after you start the car - its the aircon wind accurator or something like that :cheers: it comes from under the dash - maybe this is it maybe its not ..... i dont know.

Thanks guys, the noise comes from under the body...

I thought at first something is not being lubricated well

at start up. Althought it;s a hard noise to pinpoint.

Once the car has warmed up well and travelled a bit

it doesn't do it on idle...It seems the noise is only there

once started cold in the morning..

Grrr....

yes as stated red17. r33's have hydraulic lifters (solids in GTRs) and if the oil pressure to a lifter is low (on startup) it clicks/ticks till the pressure builds up. Known as a sticky lifter. Dont know why it does it all the time on cold starts though, or if the lifter needs replacing?

like SLY33 said. that should be where the sound comes from

but for that stupid air con noise when starting upyour car, you can get around it by just pressing the MODE button on your climate control panel so it opens that stupid thing up all the time, hence no more noise.

ie. put it to the 2nd position (head and feet)

but when you change it to windscreen mode it will click again.

worth a try

ron

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi guys my TPS voltage is reading over 2v at idle.  My Haltech ECU is reading around 40% throttle position at idle also which is really strange. Note the actual throttle position sensor is brand new…    anyone have any experience with this or know how to calibrate it on Haltech ? 
    • The OEM disk will not work on any AEM ECU, you need to use the one they made. You shouldn't have to flip the CAS or whatever you were describing, if you set the ignition sync offset correctly it can't backfire. Make sure you're using a spark plug lead on coil 1 instead of the timing loop to avoid weird issues with the timing light. Double check that your timing settings are actually correct, like is the 24 tooth configured correct or should it actually be 12 teeth for 1 crank revolution? I also found this: 305817248-AEM-Undocumented-Settings-v1-2.pdf    
    • Yeah, I don't believe the M35 uses a deadhead system.
    • Have you done your thinking backwards? 3 bar, 43.5 psi pressure drop being the presumed specification for an injector, means you need 3 bar upstream when they are firing into atmospheric pressure, and more upstream pressure than that when on boost (you add your boost to your rail pressure to maintain 3 bar across the injector) and you need..... less pressure upstream when you have vacuum in the manifold. So, presuming that you're idling at -10 psi, then you only need ~23 psi in the rail. I realise that I did not need to say all of that to you specifically Matt, once you'd realised your mistake. It's mostly there for complete clarity for others.
    • Have you reached out to the guys at Spool Imports? They are a Ross dealer, I can imagine they would have the rings just sitting on the shelf (I could be wrong).  
×
×
  • Create New...