Jump to content
SAU Community

Recommended Posts

Hey all.

I'm looking at selling these rims as they've been lying around taking up too much space and the old lady is getting cranky!

They were originally on my car when i bought it and since then i've upgraded to 18's. So they are perfect offset for R32 and 33's.

The rims are 17x8 (+35) on the front with 235/45 tyres (one is on the indicators and the other is about 40%). Rears are 17x9 (+38) with 255/40 tyres (about 30-40% tread left).

I have a pic of them on my car, but being the unlucky bastard i am, i just went to take some more detailed pics of the rims and the battery in the camera died :ninja: (the charger is at the missus's place) so i'll get some better pics tomorrow.

Im located on the Gold Coast and would prefer pickup or i can drive and meet halfway or whatever.

Im looking at $800 but will take offers (unless rediculous) as im in desperate need of money!

PM me or reply in here if any questions or interest.

:ninja:

Musky

post-25513-1184806526_thumb.jpg post-25513-1186099462_thumb.jpg post-25513-1187847059_thumb.jpg

Edited by Musky
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...