Jump to content
SAU Community

Recommended Posts

Got a Pair for sale

Got 2000 to 2500 miles on them, bought from turbo dynamics.

Come with turbo dynamics acuators that run 1Bar, these turbos can run 1.8Bar.

Also have dump pipes and downpipe to match

£1200 for them both

Selling to go for a big single. Great street turbos and I ran 11.6 with these with a shit 1.9 60FT time. Easy 10sec turbos.

Located in the UK, all postage to be paid to AU.

Might do a deal on a Big single

Link to comment
https://www.sau.com.au/forums/topic/177315-garrett-2860-5s/
Share on other sites

mate just letting u no i converted 1200 ponds to aus$ 2700,

you can get them at most performance shops brand new for $2500

and the postage will be another couple hundred so maybe ur better off selling them in da uk

Link to comment
https://www.sau.com.au/forums/topic/177315-garrett-2860-5s/#findComment-3239166
Share on other sites

  • 6 months later...

I have a single turbo setup I'm trying to sell or swap. I require the entire twin turbo setup though including water and oil lines, manifolds, piping, dump pipes, turbos (2860-5) and all other ancilleries. The only thing I don't need are the front pipes.

Pics can be found at http://iceperformance.com.au/gtr

Please let me know if you are interested.

Link to comment
https://www.sau.com.au/forums/topic/177315-garrett-2860-5s/#findComment-3610564
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just a thought, was that car and auto at any point of its life? If so, maybe whoever bridged the inhibitor switch/circuit did a not so good job.
    • Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
×
×
  • Create New...