Jump to content
SAU Community

Recommended Posts

What a rubbish weekend :)

Spent a heap of cash to go up to Bris for the weekend to watch Jambo with the Mrs, only to write off Sat with rain and today with some freak track problem. Also a bit annoyed that I couldn't redeem my Sat ticket on Sun given I would've been lucky to see 90 mins of racing on Sat which is nowhere near a full day of racing in my books.

Understand the safety first approach today and it was to right decision to cancel if the track isn't safe, but still dissapointing all the same, especially for the poor bastard who wrote off his R100 and for everyone who travelled to the event.

That's racing I guess...

Haha, yeah i got pretty burnt aswell, trust me to get burnt on the first sunny day after 2 weeks of rain.

But in all seriousness guys there is no one to blame. It was a safety issue due to wheather...

As i said earlier, if its a big weekend of drag racing racing, it will be raining... thats how it goes..

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...