Jump to content
SAU Community

Skidpan Day At Sutton Driver Training Centre 11th November


Recommended Posts

  • Replies 82
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Can we take passengers?

Is this limited to skyline owners?

Not limited to Skylines - will need to check wrt passenger, is the passenger going to be registered on the day and running as well? Otherwise Derecks insurance may not allow.

I will be PMing my bank details to everyone over the next day or two. With this number of people it is fine to go ahead, if more show interest will look at expanding the session, but at this stage will be staying to 4 hours in the morning. Most likely people will get 3 runs of 15 minutes each at least, and perhaps a 4th short run. Happy to try some different things on the day if people show interest. But at the moment it will consist of 2 cars being on the track at once, normally 1 is on end the other on the other.

The skidpan is big enough to handle 2 cars at a time. If people have any other ideas or suggestions, happy to hear them.

Go to the website link at the start of the thread, click on contact us. give him a call, just say your going to be doing the sau day on the 11th and have some questions. He might be busy at the moment, so just ask if he is ok to talk when you ring.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
×
×
  • Create New...