Jump to content
SAU Community

Recommended Posts

Hi all,

I've got a strange whistling noise which, from my perspective in the drivers seat, is coming from the front left of my car (1990, R31 4 door manual). All of my car savvy friends have had a drive/listen and have been unable to identify it, and I've also taken the car to 2 different mechanics, who were also unable to tell me what it was.

The noise is only there under a few specific conditions:

- in 3rd or 4th gear

- between 1500 and 2500 rpm

- travelling between 50 and 65km/h

- engine has to be reasonably cold or the outside temperature has to be cold, won't do it if it is a warm day or once the engine has warmed up.

If anyone has any idea what could be causing this noise, or if they've had a similar problem could you please reply here or email me at [email protected] with any help it would be greatly appreciated.

Scy

Edited by Scy

what kind of intake system do you have IE standard intake box, pod filter??

have you have the r31 for long?

whisling nosie is generally an air leak but there is only the intake system in that corner, have you had any work done on the engine latly?

do you notice any thing different when you drive it??

just trying to get an idea...

Standard intake system, I haven't added or changed anything about the car since I got it.

I've had it for almost 2 years, and the noise has only just appeared in the last 3 or 4 months.

Only work I've had done it since I got it was getting a new radiator and clutch put in and I havent noticed any mechanical issues or changes in the way it runs/drives since the noise appeared.

my mate had a whistling sound coming from the front of his car after a front mount install (cheap one), and only between sertain speeds. from what we can tell must be the air going through the fins and whistling. you said you got a new radiator, is it a good quality one. might be the same thing but with your radiator fins. just an idea.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
    • Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
×
×
  • Create New...