Jump to content
SAU Community

Recommended Posts

rb25 front cut for 3.5/4k will give you all teh parts you need

buy a r34 turbo $450~ high flow 1.5k~

will support your power goals ez and it will bolt right up to the 25 engine

a cheaper KKR 480 will also net you your power goals $800? i think but you will need a custom dump $170

or $2.2k for a GT-RS also a bolt on affair but more pricey with a bonus HKS badge

These are the best "bolt on" options.. without changing manifolds/water/oil lines etc

your power goals only 350rwhp thats a overkill for a forged engine save your money and if the 25 pops then think about rebuilding

or if you have to much money go the GT35r + RB30DET will be enuff to scare a dead man

also take into consideration tractions :)

What other mods will i need for the rb25 to get my 350rwhp?

I plan on running it from my rb20 ecu so i can use nistune to tune it will get a seperate vct controller.

I know I need the turbo. 3" turbo back system

Probably fuel pump. Will injectors be needed?

Will the afm run out of scope?

POD/Cold Air Intake

Turbo back exhaust 3"

FMIC

Full Computer (Power FC ftw!!)

Fuel Pump

Boost Gauge

Electrnic Boost controller or Turbo Tech manual bleed valve if your really tight

Turbo >___< hi flow 34 turbo or a GT SS/RS?

clutch may be due soon, injectors are maxing out and you may want cams to reduce lag

i dont think the KKR 480 will support 350rwhp without a shit heap of lag (4.5rpm+)

hi-flow 34 turbo gets my vote...

theres a sticky thread in the force induction section about what turbo making what powe with what mods..

check it out, awesome read

how much you wanting for the rb26?

If its around 3k i'll sign up now

WHat about an rb30et found one with forged pistons for 1200

It wont be 3k. Will be looking for around 4k. Turbos were bought new from greenline and have done around 2000kms probably less. Also has a 9-puk cushioned clutch that's done around 8000kms.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...