Jump to content
SAU Community

Recommended Posts

  • Replies 58
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

don't be a fool man

haven't you been listening @ all

R12 is for R12 systems

R134a is for R134a systems

DONT mix the two or your compressor wont like it

my mate also says you cant get R12 anymore and its been like that for years so if there saying its R12 its prolly one of the substitutes

if you want to waste $170 on getting that then go right ahead but i did tell you earlier my mate can do it for $50

Edited by Madaz
hrmm the place you told me, down lonsdale. alright madaz can u ask ur mate if he can regas mine than and when and where could he do it. thanks

ok mate, just rang him he said by next weekend as hes on holidays and will go into work next week and get some gas

If you have r12 which is an old gas you will need to swap it over to the new gas R134a

and if you need a regas you have a leak.

so you need to pump some nitro through it to see where it is. most of the time its the o rings on the flair nuts so just tighten so of the connections and hose fittings up.

To see if you need some refrigerant check the sight glass on the silver tank looking thing [drier] and see if its got a full charge of liquid do this while the car is running and the AC is on. also check to see if your condenser fan kicks in.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • ..and forum.r31skylineclub has been down all week....anyone know why?
    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
×
×
  • Create New...