Jump to content
SAU Community

Recommended Posts

I like the carbon air box Mark, is it a custom job or did you buy it from somewhere.

I must get something similar b4 the hot weather really sets in.......no point having pods with a HAI, I reckon the stock panel filter with a CAI setup would be better in the middle of summer.

Just a quickie

RB25 and RB20 turbo share the same sort of inlet yes? ie if I was to get an alloy intake pipe for an RB20 turbo, would it fit the 25 one no dramas?

Wanna get the shitbox fluttering its tits off for some cheap laughs :)

Time for a bash through the hills then. ;)

ya know im always down for a hillzy with a dale but the bald tires and shot suspension have me sketching... once its all done u'll be the first a call for a decent cruise.. always happy to whatch the big blue flames come out the back of ya beast!

hey pete! the carbon box is a just jap item i bought through the forums... saddest thing is i had to cut alot away for my old plumbing setup now i have heaps of gaps... you have to seal all the underside of the pipes reguardless, to creat the full box that protect from hot air. still in the middle of making bottom section up.

al in all i think the modded stock panel+box is the go. i was looking for one before i got the piping... now i cant do it but if the mines 34 has stock airbox u should too :)

On that note, has anyone had any success with these, it drives me nuts trying to set it up.

HKS EVC 5

They have all the basic sorta principle, all have the same features you need to change, only thing is yours is a bit fancier than the rest and may have some other safety features.

Got quoted about around $780 for the 100,000km service on the stag, but not including a new water pump. Apparently it doesnt need to be done until it starts leaking?! Reckon this is fair or who knows where we can get it done cheaper??

Sez

Got quoted about around $780 for the 100,000km service on the stag, but not including a new water pump. Apparently it doesnt need to be done until it starts leaking?! Reckon this is fair or who knows where we can get it done cheaper??

Sez

who was that with

i paid $600 for boostworx to do mine and a stag is just a big skyline :)

other people will recommend other forum members to look @ but essentially the choice is yours

Just a quickie

RB25 and RB20 turbo share the same sort of inlet yes? ie if I was to get an alloy intake pipe for an RB20 turbo, would it fit the 25 one no dramas?

Wanna get the shitbox fluttering its tits off for some cheap laughs :)

Inlet yes. They are the same.

Thanks scandyflick

Got quoted about around $780 for the 100,000km service on the stag, but not including a new water pump. Apparently it doesnt need to be done until it starts leaking?! Reckon this is fair or who knows where we can get it done cheaper??

Sez

Hey Ryan&sez, By all means choose who you feel comfortable working on your car, however, if your not happy with the price you have to pay for a 3 hour job on your car then i'll do it I've done about 10 or so for forum members and try to keep it fair for both you and I. I use all Genuine parts (your choice obviously) I've seen some water pump's leak at 40,000km and some water pumps that will never leak so it's not a good indication of when to change it. Because if your going to change the water pump you might as well do your timing belt aswell.

Oil (your choice)

Oil Filter (genuine)

Timing Belt (genuine)

Water Pump (genuine pumps are expensive and generic one's are pretty good at half the price)

Coolant (genuine)

Tentioner and pulley (usually dont show any wear at all and are fair expensive to change every 100 thou)

Drive belts ( powersteer, air con, alternator)

PM me for more info on prices etc.

well we just witnessed ben blow the rest of his cat out tonight... a few gunshots and flames...
lol, it was sort of like a fireworks display coming out the back of the wagon :)
haha , that scared the shit out of me , big cloud of black smoke then bang bang bang ;)

MY first words... "you killed it!!" haha

they were some pretty big flames... hehe

it lit up the freeway pretty good!

MY first words... "you killed it!!" haha

they were some pretty big flames... hehe

it lit up the freeway pretty good!

if only i had my trusty camera man in the passengers seat to take a photo !

it was something you see in jdm option or jdm insider haha

Thanks scandyflick

Hey Ryan&sez, By all means choose who you feel comfortable working on your car, however, if your not happy with the price you have to pay for a 3 hour job on your car then i'll do it I've done about 10 or so for forum members and try to keep it fair for both you and I. I use all Genuine parts (your choice obviously) I've seen some water pump's leak at 40,000km and some water pumps that will never leak so it's not a good indication of when to change it. Because if your going to change the water pump you might as well do your timing belt aswell.

Oil (your choice)

Oil Filter (genuine)

Timing Belt (genuine)

Water Pump (genuine pumps are expensive and generic one's are pretty good at half the price)

Coolant (genuine)

Tentioner and pulley (usually dont show any wear at all and are fair expensive to change every 100 thou)

Drive belts ( powersteer, air con, alternator)

PM me for more info on prices etc.

hey ryan...

so wat water pump shall i get? and wat pulley should i ask for?

and i got something to give u at the cruise!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Welcome to my 2004 Toyota Mark ii IR-V Fortuna (series 2) With a 1JZ-GTE powerplant under the bonnet (hood) it'll give me plenty of scope for power upgrades. For those who aren't familiar with imports, the 1JZ-GTE is a 2.5L 6 cylinder VVTi engine with a single turbocharger. This has the factory R154 5 speed gearbox, along with a aftermarket 2 way LSD differential (brand unknown). Under the arches are a set of CST Zero 1 alloys, 18x9 +30 225/40 up front and 18x9.5 +15 265/35 on the rear. The car was quite low in Japan and there's evidence of the wheels catching the rolled arches/fenders. The tyre's aren't great so I'm in two minds whether to replace both or just the tyres and put up with the wider wheels on the rear. The car still uses stock brakes with the addition of some braided hoses. The exterior is stock with the exception of a BN Sports front bumper and a replacement Fortuna grill  Moving to the interior, the steering wheel has been replaced with a dished MOMO steering wheel (which will get swapped for my Momo Tuner for the time being) Defi Link Gauges are mounted above the climate controls and on the A pillar, the Oil Temp,Oil Pressure,Water Temp and Boost gauges should help with spirited and track driving  The stock seats have been replaced with some retrimmed Recaro bucket seats. Being a larger build these are a little snug, unfortunately the orange isn't for me so I'll look into replacing these down the line. Other modifications include a twin plate clutch, Blitz intercooler, Evolve alloy radiator, a stainless exhaust with decat, HKS EVC-S boost controller and coil overs
    • Apologies for the long read My R34 GTT was up for sale at the beginning of spring due to a few repairs creeping up. The strut tops needed replacing, roof and bonnet (hood) painting (yay for 3 stage pearl) and the underside stripped and treated. I sold the car which allowed me to be in a much better place financially. Leading up to the sale I was already thinking about the replacement. In an ideal world it needed to be a good all-rounder. Something I can mess around with, modify, do track days, do the school run, go on long drives etc.  Options included but not limited to... Laurel C35, Evo 8/9, Civic FD2, Impreza Hawkeye, Aristo and even an Audi S4 Avant (I've already got the Mazda 6 wagon). But there was always one car at the top of the list The Toyota Mark ii JZX110 I found an advert on a Facebook group for an example in Japan, from a seller called Jon at Rising Sun Exports. A few messages back and forth and Jon calls me from Yokohama one morning (or afternoon in his case). He briefly explained the import process, the costs involved and a repeat of the advert. After much deliberation, the price was agreed and the sale was locked in. I've never imported a vehicle so I jumped into the unknown head first. The money transfer was completed through wise.com (fees apply), very easy to use and the money was with him within a day or two.  The car suspension was raised for the vessel and the car dropped off at the port. It was 7 weeks later when the bill of lading was received and the freight invoice sent to me, followed by the export certificate a couple of days after (both digital copies) In the mean time the port had been in contact. I needed an agent to deal with the NOVA (notification of vehicle arrival) along with the tax/duty invoice, this was £75.00. The port also had a fee of £100, I'm guessing to cover the cost of the 10 day 'free storage' and for moving the car off the boat etc. They need a copy of the vehicle invoice, freight invoice and export certificate to allow the vehicle to pass through customs. The vessel arrived on Tuesday 5th August, the tax/duty invoice was generated and sent over. This is generally tax 20% and duty 10% of the vehicle value. Although the invoice came in at a higher amount than I had calculated. Once HMRC had received the payment the vehicle could be released from customs. I thought once the tax/duty was paid you could collect at any point, that's not the case. Your agent will need to book a collection slot, I requested Thursday 7th which was accepted, with a 9:00am slot allocated. It was a 5:00am start from Norfolk heading to Southampton. We eventually found the compound, upon presenting the bill of lading and some ID they released the car (they drove it out of the compound to the front ready for us to load up). The email from the port stated each slot had a 10 minute window, which seemed abit farfetched but the staff said it's not a strict rule. We were there for approx. 30-40 mins in total. A week prior to collecting I contacted my garage and explained the situation, I was able to get an inspection slot that afternoon. For the registration, DVLA require the car to be insured, for this I used a company called Adrian Flux who can insure the vehicle using the VIN number. 
    • Hey guys, looking for these side skirts if anyone can help me out. 
    • Wife and I are still looking for a new home. One condition was a large enough garage for a full-size lift in one bay. Now if only we could find something... We've been looking for almost a year now.
    • Thanks everyone for the ideas! Sadly, ramps are a no go for me. With young kids at home, I do most of my work late at night while they're sleeping. Starting the car multiple times wouldn't be a great idea.  I'll go see one of those new long reach low profile jacks and take a couple measurements to see if they will fit.   
×
×
  • Create New...