Jump to content
SAU Community

Recommended Posts

Just to remind you we are all in australia and newzealand, maybe 1 or 2 in japan

i think it would cost thousands to send an engine to siberia

you may be better off looking in a euro forum.

or take your L20et to a very good engine builder and get everything balanced and rebuilt, then add some 1984 300zx turbo injectors and a better turbo from a RB20det

you will have upwards of 115 to 120kW then!

Link to comment
https://www.sau.com.au/forums/topic/190728-barter/#findComment-3435594
Share on other sites

Just to remind you we are all in australia and newzealand, maybe 1 or 2 in japan

i think it would cost thousands to send an engine to siberia

you may be better off looking in a euro forum.

or take your L20et to a very good engine builder and get everything balanced and rebuilt, then add some 1984 300zx turbo injectors and a better turbo from a RB20det

you will have upwards of 115 to 120kW then!

Sorry for bad english guys, i`m want get a manual for L20ET.

But i`m changed my mind. Now i`m want adapt a Honda C32A Engine ECU for work with my L20ET

L20ET fireibg order: 1-5-3-6-2-4 Honda fireing order is: 1-4-2-5-3-6. I`m must replace wires for spark plugs and injectors for right fireing order and adapt MAP and crankshaft position sensor, TPS sensor, intake air temperature and water sensors.

L20ET with Map must be a fun :D:P

P.S. :( Hondas ECU`s will be chipped very good and not dificult.

Excuse me for bad english.

Link to comment
https://www.sau.com.au/forums/topic/190728-barter/#findComment-3436662
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Have you flushed the initial fluid yet? It should look like a rainbow unicorn shat glitter into it. 2nd or 3rd fluid change is when you party.
    • all brand new unit from Tomei, fluid, bearings, etc. Tomei said they call it a 1.5 lsd because its 100 percent lock up under acceleration and 50 percent under deacceleration.  as I mentioned I used their fluid, install and their break-in procedure, (alot of figure 8's) but even when driving straight, or even slowly backing out of garage for first time, (at 2 mph) then driving to and from figure 8 parking lot, each tire in the rear would sporadically grab, skip, bounce, shutter and skip, shutter back a force I could feel causing clutch to slip then grab, at any speed. shaking entire car. I removed unit, since I put stock back in and all is fine, via process of elimination, its something with the lsd unit itself. I wasn't going to beat up the entire car more or change anything else for no reason as I had a feeling something in the lsd itself was wrong as everything was fine before this alone was installed and I rechecked over everything else after first time backing out I suspected an issue. I'll probably sadly already need new tires now just from trying to drive it 5 miles and performing the figure 8 break in. but if someone has any ideas I'm all ears 
    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
×
×
  • Create New...