Jump to content
SAU Community

Recommended Posts

i might go for a while just to relax before my final exam the next morning

wheres P6??

like from superdome/acer arena or state sports center ..is it around there

or is it near the place where they always have autosalon?

yeah its the car park directly across where autosalon usually is

  • Replies 55
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Y2K2 Did you mention to Justin that you were going to mention this meet on other forums?

No i didn't,

i have heard about it from a couple of other groups

the evo, silvia etc

so i was just trying to find out if a group of skylines from here are going.

i haven't seen any chat about it on this site and there seems to be abit of buzz going around about it.

have i done something wrong, should it be taken down?

photos came out garbage- but what can you expect from a 2mp camera phone being used in a dimly lit carpark. meh

mint 1600; what it wants to be when it grows up; a 'unique' 32 GT-R and the most Evos i've seen in one place

post-19705-1195557429_thumb.jpg

post-19705-1195557456_thumb.jpg

post-19705-1195557494_thumb.jpg

post-19705-1195557542_thumb.jpg

post-19705-1195557573_thumb.jpg




  • Similar Content

  • Latest Posts

    • Did you take the MX5 for a Blat around the Track at all?
    • LOL, "they said it might be slippery"..... 30 seconds in your off, 60 seconds in white twin backs into the corner That new track looks good, and the Datsun was chopping cars quite nicely     
    • I'll get one of these also just for giggles
    • I bought 6 new spark plugs to compare readings. They will be here tomorrow and ill see if meter is far off if it all. I know one is at least reading 0 so its best replace all anyway if one is bad, from experience. I still have to test the harness just to be sure its not a double issue and I waste my time haha-the old plugs are iridium I always thought those lasted more than 50,000 km.
    • If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
×
×
  • Create New...