Jump to content
SAU Community

Recommended Posts

hi guys. just wondering if anyone has done the whole, water spray on the fmic and radiator?

i was thinking of running it off the window washer resoviour with a small motor, than splicing it into 2 foggers, one for fmic, one for radiator.

i need some inspiration and ideas.

anyone done it? :D

This is a DIY IC spray done on a Z32. Guess you could use the same principles.

http://www.pexcom.com.au/z32cms/e107_plugi...php?content.315

Do skylines have the rear window washer? if they do maybe you could take the line that goes to the rear window washer and reroute it to the IC.

another good mod would be to make an air guide to force air through the fmic. otherwise air will hit the FMIC and just go around/under it.

there's some good info in this thread: http://www.aus300zx.com/forum/showthread.php?t=261337

these pics are from that thread. the pic below is of the Unique Autosports Slotcar.

custom_air.jpg

And this is what another member made.

car1-2.jpg

all i've done to get my car ready for summer is replace the upper hose with a new stock one, replace the lower hose with a alloy hose (stock rubber can be sucked flat under extreme thrashing = no coolant into engine), radiator rodded & flushed and put new toytoa red coolant in.

Edited by Sandeep

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...