Jump to content
SAU Community

Recommended Posts

hey everyone, skyline bodykit 4 sale, need to offload asap!

1 x 400R frontbar (unpainted)

1 x set of nizmo sideskirts (unpainted)

the bar and skirts owe me just over $1k,

never been fitted or painted,..

open to offers, lemme know..

Mobile : 0405 650 930

asking $650 for the lot ...

Link to comment
https://www.sau.com.au/forums/topic/19588-r33-bodykit-brand-new/
Share on other sites

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

Sounds nice but your about 3mths too early for me.

I just ordered a 400R sideskirts and a 400R rear bar last weekend and now im struggling to get funds for the painting/fitting.

A 400R would go nicely (although verrrrry low).

can i also get pictures, interested in purchasing complete package - also is it for a series 1 or 2?

pm or email me please on: [email protected]

cheers

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...