Jump to content
SAU Community

Recommended Posts

The Shaker is the truck-mounted piece of machinary that you drive your car up onto. When operational, it simulates severe driving conditions that are more indicative of driving down the OLD toll bar road (as in straight down) instead of a potholed piece of narrow bitumen (often referred to by QT as a 'highway').

It was designed to be used with trucks and full-chassis vehicles, but some lame-brain has decreed to use it with all vehicles.

Monocoque-design vehicles -can- handle the punishment, but it can cause stress fractures. The new car that was destroyed happened because the inspector from QT did not close the car door before the test began - and since the doors and front & rear windows are what give new cars their structural integrity.... well - you can guess what happened....

Transport disavowed all responsibility and told the bloke to contact the manufacturer because it was a faulty vehicle. The manufacturer told him that it was QT's fault because they hindered the ability of the car to observe its structural integrity (by not closing the door). Bloke is left in the middle out of pocket with a hot potato.

Link to comment
https://www.sau.com.au/forums/topic/19940-the-shaker/#findComment-419017
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Yeah man, absolutely. You can try pushing me all the way in swapping the R34 for an E9x M3 
    • It's almost certainly going to be some amount of pads compound transfer onto the rotors. It will probably go away after you've run them for a bit. If not, pull it all out, lightly sand the rotors, scuff the pads, and rebed.
    • no one recommending speedtek gearsets?   i'm in the same boat as Cosline but rwd, I am holding boost back in third to 600nm at the hubs to save the gear as i make nearly 750nm at the hubs on a mainline
    • Hi guys,  I just replaced my pads with blue stuff and flushed fluid. The pedal and brakes feel fantastic but I'm getting very slight pedal stutter under any kind of braking. Not every time, maybe 1 in 10 and not under any heavy braking, mostly occurs as I'm reaching a stop. It feels like abs engaging but it's so fast, there and gone in under a second and no abs flash on the dash.  Any ideas what could be causing this?
    • How does dead head help with emissions? Is it being claimed for emissions because fuel in the tank isn't being heated up by being pumped around, hence should condense more? One part that is a negative about dead head is heating the fuel at the rail a lot more (IE heat soaking at traffic lights) and this causing lean outs on takeoff afterwards. If my thoughts above are correct, I wonder how different the tail pipe emissions become with the lean outs vs less fuel tank emissions into a charcoal canister 
×
×
  • Create New...