Jump to content
SAU Community

Recommended Posts

The Shaker is the truck-mounted piece of machinary that you drive your car up onto. When operational, it simulates severe driving conditions that are more indicative of driving down the OLD toll bar road (as in straight down) instead of a potholed piece of narrow bitumen (often referred to by QT as a 'highway').

It was designed to be used with trucks and full-chassis vehicles, but some lame-brain has decreed to use it with all vehicles.

Monocoque-design vehicles -can- handle the punishment, but it can cause stress fractures. The new car that was destroyed happened because the inspector from QT did not close the car door before the test began - and since the doors and front & rear windows are what give new cars their structural integrity.... well - you can guess what happened....

Transport disavowed all responsibility and told the bloke to contact the manufacturer because it was a faulty vehicle. The manufacturer told him that it was QT's fault because they hindered the ability of the car to observe its structural integrity (by not closing the door). Bloke is left in the middle out of pocket with a hot potato.

Link to comment
https://www.sau.com.au/forums/topic/19940-the-shaker/#findComment-419017
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...