Jump to content
SAU Community

Rb26 Engine Rebuild Parts-forgies,bearings,conrods,cams,headgasket,oil Pump Etc

Nisswreck

By Nisswreck,
in Wanted to Buy

 Share

Recommended Posts

Nisswreck Grand Master

Nisswreck

Posted
Posted

im rebuilding my motor in the GTR (R33) so im after everthing to rebuild it strong

forgies

conrods

bearings

rings

oil pump

headgasket

bigger cams

cam gears

valve stem seals

etc etc

also after a power fc, bigger injectors, cams, dump/front pipes, greedy plenum and a twin turbo kit

can swap for parts if that works out better for you

cheers

steve

MAD R32 GTR ! Collaborator

MAD R32 GTR !

Posted
Posted

hey man!

I've got some 800cc injectors, chip torque programmable ECU, z32 Air flow meters, pods and plugs

Contact me on [email protected] if your keen

Thanks

[200] Mentor

[200]

Posted
Posted

I can get you a set of Wiseco forged pistons in .020' oversize (86.5mm bore) and a set of forged Eagle connecting rods for $1650 delivered.

Or you can pay over 2k through the sponsors...

Up to you.

Brand f*kn new too!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Haggerty
      RB25DE NEO with Haltech ECU

      By Haggerty · Posted

      Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • brillo
      Leak from Tokico BM50 Brake Master Cylinder

      By brillo · Posted

      Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • MBS206
      Cas issue

      By MBS206 · Posted

      It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • nash47
      Cas issue

      By nash47 · Posted

      Yes sir am asking is there possible way from aem tuner from wiring pins 
    • MBS206
      Cas issue

      By MBS206 · Posted

      Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...