Jump to content
SAU Community

Recommended Posts

Item: Cusco Rear Upper Arms

Condition: BRAND NEW

To Fit: R32 GTR

Location: Lower North Shore, Sydney

Contact: Andrew ([email protected] or 0418 881 113)

Price: $400

Comments:

231 474L Nissan - Skyline BNR32 - +10 to -6mm

FEATURES

- Provides proper camber angle and improves car movement

- Prevents irregular tire wear and holds tire to the asphalt, improving traction.

- The good alignment will enable better traction as well.

- The turn buckle will correct the camber with the change in height.

Actual Photos:

cusco_rear_upper_arms_1.jpg

cusco_rear_upper_arms_2.jpg

cusco_rear_upper_arms_3.jpg

Item: Cusco Front Pillowball Tension Rods

Condition: BRAND NEW

To Fit: R32 GTR or GTS-4

Location: Lower North Shore, Sydney

Contact: Andrew ([email protected] or 0418 881 113)

Price: $340

Comments:

231 473 ASN Nissan BNR32 RB26DET

FEATURES

Reduces the amount of suspension flex during hard cornering.Increases greatly the handling response going into corners by adopting pillow ball mount on the body side. High rigidity pillow rods balls used to hold down tires under braking. Increases straight line stability by reducing toe out and friction.

The turn buckle type allows simple adjustments with the parts on the car.

The pillow balls are covered by rubber boots for increased durability.

Actual Photos:

cusco_tension_rods_1.jpg

cusco_tension_rods_2.jpg

cusco_tension_rods_3.jpg

cusco_tension_rods_4.jpg

Item: Trust Sump Extension

Condition: BRAND NEW

To Fit: Any GTR or car with RB26 engine

Location: Lower North Shore, Sydney

Contact: Andrew ([email protected] or 0418 881 113)

Price:$440 SOLD!

Comments:

13525900 Nissan RB26DETT Oil Pan Up Grade Kit

Cure for your Sump Baffle Syndrome (SBS) :cheers:

When the vehicle is on the corner or the time of acceleration and deceleration, oil in the oil pan will lean or jump. To prevent these to happen, a baffle is assembled in the pan of stock engine. Though, in terms of sports driving, it is almost impossible to achieve its purpose because the size of the baffle is restricted to cut down the production cost. If oil flows to one sidey, air goes into the pipe instead of oil and interrupts the continuous oil lubrication. Without oil, metal surfaces will contact directly with each other, then the temperature rises, causing wear. On the other hand, Trusti movable baffle plate is made to achieve stable oil lubrication at any situations such as curving, acceleration, and deceleration. And it will secure the improvement of engine performance from street use to the drag racing or circuit run.

Actual Photos:

http://www.andrewho.com/misc/forsale/trust_sump_extension_1.jpg

http://www.andrewho.com/misc/forsale/trust_sump_extension_2.jpg

http://www.andrewho.com/misc/forsale/trust_sump_extension_3.jpg

  • 1 month later...
  • 2 weeks later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...