Jump to content
SAU Community

Recommended Posts

Ive been doing some searching on here about some short shifter kits

I really think nismo is the way to go

1. The kit says it reduced throw by 10%, is this even that noticeable, i used to drive a s15 and that had a much shorter throw than the 32

2. I also read on here that these kits wear out your syncros, is this true?? my gearbox feels a bit notchy going into 2nd, is this fixable

Link to comment
https://www.sau.com.au/forums/topic/209531-nismo-short-shifter-kits/
Share on other sites

I have one. I noticed a difference but it is harder to shift. I am thinking about taking it out. If you know some one with one and ask if you can see have a look. There is no need to drive around the block. Have a feel and see if you like it before spending the money

Mark

Edited by markiyq2

short shift kits are a lot harder on syncros because the syncros are designed to synchronize the gear speeds with the time taken in moving the factory throw... by shortening the throw you make quicker gear changes and therefor syncros do not have sufficient time to synchronize gear speeds...

havnt worded that real well but i hope you get what im saying :D

short shift kits are a lot harder on syncros because the syncros are designed to synchronize the gear speeds with the time taken in moving the factory throw... by shortening the throw you make quicker gear changes and therefor syncros do not have sufficient time to synchronize gear speeds...

havnt worded that real well but i hope you get what im saying :D

Nah. Sounds like a load of crap. :nyaanyaa:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...