Jump to content
SAU Community

Recommended Posts

Ok, what i want to know is where to i connect the wastegate line to on this turbo? Usually there is a little connection point on most turbos on the COMPRESSOR cover, though there is nothing on this turbo. It is a VQ30 turbo. My old rb20 turbo did have the connection on the comp cover but this turbo doesnt. So where do i connect the wastegate line to? Should i add a little connection somewhere on the outlet pipe?

http://www.skylinesaustralia.com/forums/at...=&postid=440959

http://www.skylinesaustralia.com/forums/at...=&postid=440966

Link to comment
https://www.sau.com.au/forums/topic/21060-help-asap-for-turbo-novice-pics/
Share on other sites

See the cylindrical looking thing with the little yellow cover on the side... I'm dead sure that's the wastegate actuator / diaphram and that's connected to the wastegate by some lever (can't see on the pics).

I'm sure that you can run the line from your wastegate line into that connector that the yellow cover is hiding.

I suppose you also need to find out how much pressure is required to open the wastegate.

The line can go from the yellow thing to anywhere on the turbo outlet pipes before the throttle... If you have a bleed valve or boost solenoid then you run it from there... But you don't have to connect the wastegate actuator to the compressor housing - just anywhere where there's boosted air ;)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...