Jump to content
SAU Community

Recommended Posts

  • Replies 54
  • Created
  • Last Reply

Top Posters In This Topic

Could be a good thing, as all you do is find a registered inspection place and they do the paperwork

Like in vic, when I got a car registered at an isnpection station all they do is stamp the paper work, the inspection place checks compliance/legality, issues a roadworthy cert and all is good:D

Here's hoping its part of the govt cutbacks, so they dont need to employ a heap of people at regency. How good would that be.

Hippy in NSW if a car is over xx (cant remeber) years old, it must be inspected and a certificate of roadworthiness issued. The upside is that there is no way in hell that poor old regency would be able to handle these sorts of numbers of vehicles, therefore it would be outsourced - by by regency...hehehe

Originally posted by hippy

yeah but what about the outsourced company?? they could have pricks there .. although unlikely since it will be performanced based??  so they're likely to let shitbombs pass..

If they are pricks, no one will go there - reputations carry far and wide.

I found that most places in vic were actually really good (those places that were absolute sticklers, everyone knew about and no one went there), didnt worry too much if the car was a little low, or exhaust a bit noisey, minor bending of the rules as long as it wasnt bodgey back yard stuff.

In NSW authorised garages/workshops carry out the yearly rego inspections. There are literally hundreds of these authorised workshops, & they're all privately owned. In other words places like RPM Performance Centre, Tilbrook Auto Dyno & the like :) Some workshops will pass anything, whereas others are known to be very tough. It’s very simple, if you don't get the result you’re after (a pass) then you go elsewhere. Unless your car has major faults you WILL find someone to pass it! Been there done that :)

The authorised inspection workshops in the NSW system can lose their licence if they are linked to an unroadworthy car (ie it gets defected due to a major safety fault). This ensures that they don't just pass anything. It doesn’t stop many authorised workshops from doing extremely relaxed inspections. I’ve had places do a brake test on my car (the inspection requires a brake test print out) & they haven’t even started my car! The bottom line is… what the owner does to his/her car immediately after it leaves the workshop is out of the workshop’s control. So as long as the basics are ok you’ll be fine.

I very much doubt the SA Government has the funds to increase staff at Regency to cope will yearly inspections. Hence it will be contracted out in the same fashion as NSW & VIC etc. They is no way in hell one single workshop will be able to cope with all cars that fall within the inspection criteria.

The people that will have trouble with a yearly inspection system are those with shitbox cars rusting to pieces & blowing huge amounts of smoke & the like. These kinds of faults can’t be removed & re-installed if you get my drift – no pun intended :D

Steve,

In NSW all cars over 2yrs old are subject to yearly rego inspections. In my 15yrs in NSW I never had a car fail a yearly inspection. It sometimes took a second workshop but I still never failed :D

Dont raise your hopes up ppl!!!

Anything that the government touches or involves in will only make our lives more miserable and EXPENSIVE.

So instead of spending our good dough on mods and getting it done right, we will in the future

1. Waste our times at car inspection place....the line may be very long if everyone need to get it done.

2. pay fees every year or so...I bet GST still applies here :P

3. Expose our cars to a the public regularly......it would be a good place for car thieves to hang around don't you think :D:(

4. The cops still be able to defect your cars on the roads....Regency will still be Regency as usual!!!

I don't know what's so good about this except more revenue for the government.

It will only get from bad to worst :(

No my cup is quite full at the moment.

Life could not be any better so far :)

The politicians and politic in Australia are rediculous.

May be they should impose a rule and do a yearly IQ/health/usefulness check on the politicians and see how many get written off per year.

That I like to see :P

Thats the funny thing, you could be the biggest fark head in the world and get voted in to politics, no intelligence/education required, just a personallity that people will vote for!

Scary stuff, but I still prefer to look on the upside to the rego inspection things, rather than focus on the bad...lol

Bottom line? which would you prefer:

all those shit boxes that drive around on the street, potential accidents waiting to plow into your car, or worse still you or your family left in peace while the drivers of nice cars get defected all the time for bullshit like 'I think your car is not legal ride height, so you better get down to regency'

OR

those shitboxes removed from the street AND you get to have your vehicle inspected by the workshop that you have been forking out your hard earned mod dollars (like in Vic)

Why not ask Miss Nismo who she would have preferred to have the vehicle inspected by when she changed the rego to SA in her R32, or one of the many guys who were defected with imports?

and lastly,

would you bitch if as you were driving home from getting defected, you pulled up at the lights next to some rust bucket spewing smoke and bouncing all over the place because the suspension is so rooted, yet they drive around all day evey day with out a care in the world?

All I am saying is, look at the big picture. Bottom line, I would be happy to pay a few dollars to have my car inspected if I knew that dangerous pieces of junk were being removed. With any luck their will be better spinoffs (easier vehicle inspections for rego transfer/defect) as well.

Either way, neither you nor I will change it, but I think it aint all bad, you choose to think it is. I hope your wrong:p

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I certainly fall into the annoyed camp, but glad to hear that if it's happening at low boost then I'm not likely going to blow a turbo and end up with metal shards in my oil. Just feels like it prevents me from really driving it without hesitation and "peak" performance. Wonder if it's the VCAM, it did an impressive job of shifting the torque curve and faster spool, but maybe now it's "too fast" and there's too much air for how open the throttle is.  Based on some other threads, will also do some reading on synchronizing the actuators. They are the default actuators that come on the Garrett's and I would think they would be set the same coming from the factory, but if the turbos don't actually work exactly the same way at the same time as previously mentioned, it would be worth making sure the actuators are actuating together properly
    • I went down this rabbit hole before, ended up sourcing a motor from the UK (I'm in Japan) which also didn't function correctly. With the original motor, I disassembled it and reassembled it and it works somewhat, sometimes. What I could deduce from all my screwing around is that there is calibration of the gears on the inside of the motor and two ramps on the main gear which activate switches that operate the motor and move the sunroof either to retract into the roof or tilt. Where I got stuck was that, it seemed in my case that one or both of the switches that are activated by the ramp on the gear did not always activate and thus the motor did not move, causing it to sometimes not retract or tilt (apologies, I've forgotten which way it didn't work.).  Of course this part is discontinued at Nissan now, it's the same part in the S15 but no other models. I also contacted the manufacturer of the component for schematics - forgot the name, they're based in Gifu - but they declined to share the information due to being bound by an NDA, sadly. Looking through my pictures now, it seems I last had a crack at this in 2022. See, I so kindly wrote "open" and "close" next to the switches. If you figure it out, please do tell me. Those little switches, with the red buttons may need to be replaced.
    • It says 300ZX, does that make it an Aus delivered car? Funny how back in the day I just couldn't care less about Z32's and these days I am just in love with them. Back when Nissan was into pushing the envelope. 🤣
    • Hi guys, just after some guidance with an R34 sunroof that has stopped working correctly. It still opens and closes perfectly fine, but it no longer tilts/vents up or down. As a result, the rear of the glass now sags a bit as it drops down slightly in order to retract into the roof, but now it can't pop upwards into a flush position. I’ve probed the pins on the back of the switch connector with a multimeter and it seems like both switches (for open/close and tilt/vent) still work correctly. Any ideas on what it could be, or where I should even start in terms of diagnosing? I'm sure someone's had this issue before but I haven't been able to find anything online relating to this specific issue, most of the issues are with the seals leaking or the motor failing entirely. Thanks in advance!
×
×
  • Create New...