Jump to content
SAU Community

Recommended Posts

LOOKIN FOR

NON TURBO

32 OR 33 2 DOOR

LOOKIN AT KEEPIN BELOW $9000 OR SWAP FOR MY MINTRUCK LET US NO WHAT U HAVE.... THANKS

P.S JUST PM ME I COME ON HERE ABIT AND IS BEST WAY TO GET ME

Edited by LOW17F

For sale or swap

1993 Skyline R32 GTST

235000kms 6 months rego

5 Speed

Turbo timer

Sunroof

17inch Volks with near new rubber

Standard apart from Exhaust and Pod filter

Needs bonnet and front bar/side skirts paint.Stone chips & general road wear

Rear quarter panel needs repair and has small section of rust in both rear wheel arches

Aircon working but compressor has seized once and needs replacing.

I have had this car for last 6-7 years as my daily driver and has been extremely reliable, still

average 450-500 Kms per tank.

Only parts needed replacing were aircon belt tensioner pulley bearing and

water pump.

Dont know what if anything it needs for RWC but if someone interested will get it checked out.

Looking for $8500 ono or possible swap,Looking for something more suitiable for towing as

have bought Jetski

Prefer something like Suzuki Vitara or similar but will consider all offers with possible cash

either way.

Vehicle located Brisbane southside.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...