Jump to content
SAU Community

Recommended Posts

Hey Guys,

I picked up my R34 yesterday. I'm so happy, so I had to post up some pics :blush: They are a bit covered in rain, but this is the only gap I got :D

post-29218-1208417926_thumb.jpgpost-29218-1208418124_thumb.jpg

post-602-1134975445.jpg

... and I had to take some pics of the pair :blush:

post-29218-1208418429_thumb.jpgpost-29218-1208418522_thumb.jpg

edit: and some interior pics just for Karl :w00t: Sorry about the bad quality of these. Just ran out and grabbed them :banana:

post-29218-1208420776_thumb.jpgpost-29218-1208420832_thumb.jpg

post-29218-1208418269_thumb.jpg

Edited by R33-GTS
Link to comment
https://www.sau.com.au/forums/topic/215293-my-new-r34/
Share on other sites

Thanks :banana: Yea, I have pretty big plans actually.

I'm building it to mainly compete in the autotest series. For this braking and suspension are key. Also, bucket loads of power will not do any favours, so to start I'll be going for between 200 and 210 rwkw. Here is the list to get there...

Engine

- RB20 wastegate actuator (increases boost to 10psi)

- FMIC

- CAI

- High flow filter

- Power FC (if I can find one :D)

- 3" turbo back exhaust

- Iridium sparkies

- Tomei Fuel pump

- Surge tank

Suspension wise

- Tein SS with EDFC

- Pretty much a whole heap of whiteline stuff to make everything adjustable

Braking

- G4 Racing brakes all round with nice big rotors for big stopping power

Body Kit

- C-West front, sides and rear

- z-tune front fenders

- Cross Factory rear fenders

- 18x10.5 Work Meister rims with some 285 or 295 rubber (lots of grip )

- East Bear vented bonnet

- R34 GTR spoiler

ICE

- Pretty much pioneer everything from head unit to two shallow 12" subs in a custom moulded boot

Link to comment
https://www.sau.com.au/forums/topic/215293-my-new-r34/#findComment-3802959
Share on other sites

Thankyou to which ever mod reopened the thread :banana:

I gotta say dude you got a damn fine ride there, looks real clean.

Looks like you've got a good plan on where your going :)

If you want to change from center triple gauges to GTR mfd screen, I might be able to help with the wiring :D

Link to comment
https://www.sau.com.au/forums/topic/215293-my-new-r34/#findComment-3803392
Share on other sites

Thanks for the comments guys :)

Yea, there is definately a big difference between the R33 NA and the R34. Turbo pulls a lot harder, thats for sure :banana:

Yes... it is definately a manual this time. After driving an auto for a while, I was definately missing the manual. Wouldn't go auto ever again lol

Link to comment
https://www.sau.com.au/forums/topic/215293-my-new-r34/#findComment-3803757
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...