Jump to content
SAU Community

Recommended Posts

Hi all,

Just wondering if neone could tell me what this is or what they think it is. Basically i can only here it at idle and very low in the rev range as its not that loud just irratating (Spelling). Its coming from the engine bay and sounds to me like a leaking exaust manifold but it did it before i got my extractors and now it still does it with the new ones and new gasket, i changed the oil and its still there? someone once told me that its normal for Double Over Head Cam engines to do this but i disagree, the car still runs fine and isnt lacking in power its just really starting to annoy me.

Ne Help Much Appreciated.

Cheers

John

Link to comment
https://www.sau.com.au/forums/topic/21687-ticking-sound/
Share on other sites

In my old 202 it was the hydraulic lifters, and my GTS-T makes this same sound. I was told cheap oils can make your car do this, but I have been running fully synthetic in mine, so Im not too sure whats going on. Anyways, It never hurt my 202 and my 33 is going strong.

Link to comment
https://www.sau.com.au/forums/topic/21687-ticking-sound/#findComment-461315
Share on other sites

  • 2 weeks later...

could be hydaulic lifters.

I have been told that Mazda's have a bad problem with this, and they have a special oil additive to fix it.

Put it in with the oil run for 20mins until noise is gone, then drain oil. Apparently it (oil) comes out black, thick and lumpy. Basically the additive is an internal engine cleaner.

Ask your friendly Mazda dealer about some

Link to comment
https://www.sau.com.au/forums/topic/21687-ticking-sound/#findComment-492424
Share on other sites

"yeah i always get bad fumes in the cabin if sitting in traffic for a while. gives me a saw throat after extended preiods, im assuming its not real good for you."

N/A_R33,

mate you have an exhaust leak, go to an exhaust specialist and have it checked out...they will find where it is...

i had the same problem with a previous car, after changing the exhaust manifold gasket many times and not fixing the problem, i discovered that the manifold face was warped and not sealing properly...

had the manifold machined and problem fixed!

Cheers

Link to comment
https://www.sau.com.au/forums/topic/21687-ticking-sound/#findComment-492624
Share on other sites

i had it checkd and it seems one of the 'rear' bolts for the exhaust manifold is missing, sposedly this is a common problem in 33 gtsts and 95% of the time people dont bother replacing them as its a huge job, i can definitely hear the clicking of the air leaking but as far as power/econoy nothing seems to be affected, two different tuning shops told e not to worry about it unless it starts to get worse, any suggestions ? anyone know how much it usually costs to get the bolt fixed ?

Link to comment
https://www.sau.com.au/forums/topic/21687-ticking-sound/#findComment-492731
Share on other sites

I got mine engine tap tap tap last month when cold start, noise gone when warm.

On way back from GOR cruise, my car misfiring ratatatata hard on 3rd gear acceleration. The next morning oil pressure running low, car has flat spot everywhere but that cold start tap tap tap noise totally gone....... what the?????????

Car is slowly getting better and better to drive, but still a bit flat spot and won't make boost on 1st gear (gauge only goes to 0). Now boost only comes in 2nd gear or higher (gauge goes to a bit over the halfway mark between 0 & +7).

On cold start, oil pressure will go past 6 mark on +/-1200rpm idle. When warm, on 700rpm idle oil pressure is a little less than 2. When driving around 2500-3000rpm oil pressure is about 4, and cruising 4th gear 60kph about 2000-2500rpm the oil pressure drops to about 3 or 3.5 mark.

Strange..... very strange......

Link to comment
https://www.sau.com.au/forums/topic/21687-ticking-sound/#findComment-494048
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
×
×
  • Create New...