Jump to content
SAU Community

Recommended Posts

another A31 Cefiro and Y31 cima just arrived for wrecking

the cefiro has tein coilovers, exhaust, wheels

cefiro manual conversion complete kit $1500 *on special* was $1800

prices will be up very soon

post-34059-1211503904_thumb.jpg

Edited by Nisswreck

Looking for off Cima:

Front Struts:

Off Passenger side front seat:

Plastic cover over electric motor on outside of seat

cable drive that runs between motors at front of seat

seat belt guide

Edited by SideWaysChef

All cefiro seat belts and front left belt buckle?

Headlights and grille?

Tail shaft centre bearing?

Left hand front steering rack boot?

Split pins for front lower ball joints?

Front sway bar link pin rubbers?

Might as well get most of it out the way....

I'm pretty sure rack boots are a universal item you can get from most automotive places, as are split pins for ball joints.

Dont know unless you ask right? :( I dont know whats what to be honest...

Cheers mate...!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
×
×
  • Create New...